Жарты қуат нүктесінің маңызы

Electronics reference point
The half power point is the point at which the output power has dropped to half of its peak value; that is, at a level of approximately 3 dB. In filters, optical filters, and electronic amplifiers, the half power point is also known as half power bandwidth and is a commonly used definition for the cutoff frequency. In the characterization of antennas the half power point is also known as half power beamwidth and relates to measurement position as an angle and describes directionality.

This occurs when the output voltage has dropped to of the filter's nominal passband voltage and the power has dropped by half. A bandpass amplifier will have two half power points, while a low pass amplifier or a high pass amplifier will have only one. The bandwidth of a filter or amplifier is usually defined as the difference between the lower and upper half power points. This is, therefore, also known as the 3 dB bandwidth. There is no lower half power point for a low pass amplifier, so the bandwidth is measured relative to DC, i. e., 0 Hz. There is no upper half power point for an ideal high pass amplifier, its bandwidth is theoretically infinite. In practice the stopband and transition band are used to characterize a high pass.

In antennas, the expression half power point does not relate to frequency: instead, it describes the extent in space of an antenna beam. The half power point is the angle off boresight at which the antenna gain first falls to half power (approximately 3 dB) from the peak. The angle between the 3 dB points is known as the half power beam width (or simply beam width). Beamwidth is usually but not always expressed in degrees and for the horizontal plane. It refers to the main lobe, when referenced to the peak effective radiated power of the main lobe. Note that other definitions of beam width exist, such as the distance between nulls and distance between first side lobes.