Сравнивайте с английским: нажмите на абзац — оригинал откроется в окне. Кнопка EN под абзацем показывает его прямо в тексте.
Введение
Процессор dbx Model 700 Digital Audio Processor был профессиональным аудио ADC/DAC комбинацией, который оцифровывал стерео аналоговый аудио вход в битовый поток, который затем был закодирован и инкапсулирован в аналоговый композитный видеосигнал, для записи на ленту с использованием видеомагнитофона в качестве транспорта. В отличие от других аналогичных устройств, таких как Sony PCM F1, модель 700 использовала метод, называемый Companded Predictive Delta Modulation, а не теперь распространенную модуляцию импульсного кода. В момент его внедрения в середине 1980-х годов устройство было первым коммерческим продуктом, использующим этот метод, хотя он был предложен в 1960-х годах и прототипирован в конце 70-х годов.
The dbx Model 700 Digital Audio Processor was a professional audio ADC/DAC combination unit, which digitized a stereo analog audio input into a bitstream, which was then encoded and encapsulated in an analog composite video signal, for recording to tape using a VCR as a transport. Unlike other similar pieces of equipment like the Sony PCM F1, the Model 700 used a technique called Companded Predictive Delta Modulation, rather than the now common pulse code modulation. At the time of its introduction in the mid 1980s the device was the first commercial product to use this method, although it had been proposed in the 1960s and prototyped in the late '70s.
Теория действия
Модель 700 преобразовывала аналоговый звук в цифровые данные с использованием типа модуляции дельта-сигма, называемой "Companded Predictive Delta Modulation" или "CPDM" (оба товарные знаки). В традиционном, одноинтегрированном дельта-сигма-АДК напряжение входного сигнала сравнивается с выходом интегратора. Если входный сигнал выше, чем выход интегратора, записывается 1, и интегратору дается команда увеличить на определенное количество. На каждом тактовом цикле сравнение повторяется (и записывается еще один 1), пока выход интегратора не превысит входное напряжение, в этом случае записывается 0, и интегратору говорят уменьшить. Таким образом, интегратор пытается следовать за входным сигналом как можно ближе. При подаче сигнала постоянного напряжения (или при полном удалении ввода), выход будет "бездействовать" и производить поток чередующихся 1 и 0. Декодер, слушающий этот поток, будет производить небольшой синусоидальный или треугольный выходной сигнал, даже если правильный выходной сигнал должен быть плоским: это форма квантовой ошибки. Модель 700 отличается от классической модуляции дельта-сигма заменой одного интегратора сложной системой сравнителей и линейных фильтров прогнозирования высокого порядка. Это было сделано для того, чтобы уменьшить ошибку квантования, и частично достигается путем изменения эффективного "шагового размера" кодера на основе ранее записанной информации. (Так увеличивается или уменьшается скорость убийства.) Система также имеет два аналоговых этапа предварительной обработки, которые сжимают входный сигнал как в амплитуде, так и в частотной области, чтобы более точно соответствовать возможностям кодера. Это сжатие выполняется адаптивно на основе ранее закодированного сигнала и обращается в сторону декодирования.
The Model 700 converted analog audio into digital data using a type of delta sigma modulation, called "Companded Predictive Delta Modulation," or "CPDM" (both trademarked). In a traditional, single integrated delta sigma ADC, the voltage of an input signal is compared to the output of an integrator. If the input signal is higher than the integrator's output, a 1 is recorded, and the integrator is given a command to increase by a certain amount. On each clock cycle, the comparison is repeated (and another 1 is recorded) until the integrator's output exceeds the input voltage, at which point a 0 is recorded and the integrator is told to decrease. In this way, the integrator attempts to follow the input signal as closely as it can. When fed a constant voltage signal (or when the input is removed completely), the output will "idle" and produce a stream of alternating 1s and 0s. A decoder listening to this stream would produce a small sinusoidal or triangle wave output, even though the correct output should be flat: this is a form of quantization error. Where the Model 700 differs from classical delta sigma modulation is in its replacement of the single integrator with a complex system of comparators and high order linear prediction filters. This was done in order to reduce the quantization error, and is accomplished in part by changing the effective "step size" of the encoder based on previously recorded information. (Thereby increasing or decreasing the slew rate.) The system also has two analog pre processing steps which compress the input signal in both the amplitude and frequency domain, in order to more closely match the abilities of the encoder. This compression is done adaptively based on previously encoded signal, and is reversed on the decoding end.