Теннесси штатындағы Пеллисиппи тас жолы

Highway in Tennessee, United States

The Pellissippi Parkway was initially constructed between I 40/I 75 and Solway from 1970 to 1973 in order to improve access between Knoxville and Oak Ridge. A proposal to extend the highway to US 129 arose while the initial section was under construction, and this occurred in multiple segments between 1987 and 1996. The parkway was extended to its current eastern terminus in two sections, which opened in 1996 and 2005, and is currently planned to be extended approximately 4 mile (6 km) to US 321. This plan has been the subject of intense community opposition from locals, however, and has been repeatedly delayed as a result.

The Pellissippi Parkway comprises I 140 and two sections of SR 162 that seamlessly extend from either end of the Interstate Highway segment. The northern segment of SR 162 runs 5.84 mile (9 km) from SR 62 at Solway south to I 40 and I 75 in Knoxville. The southern segment of SR 162 begins at US 129 and runs 2.74 mile (4 km) to SR 33 within Alcoa. The northernmost 4.6 mile (7 km) of the parkway is a four lane limited access highway, and the remainder is a controlled access highway. Running in a diagonal southeast–northwest alignment, the I 140 stretch is signed as an east–west route, and both SR 162 sections are signed as north–south. In 2022, annual average daily traffic volumes ranged from 69,195 vehicles north of I 40/I 75 to 14,905 vehicles at the eastern terminus. The Pellissippi Parkway begins at a directional interchange with SR 62 (Oak Ridge Highway) at the east end of the unincorporated community of Solway in western Knox County. This is on the east side of the Clinch River a short distance from Oak Ridge. Here, there is no direct access from westbound SR 62 to the parkway. The parkway then heads southeast as a limited access four lane divided highway. It crosses Beaver Creek and has a five ramp partial cloverleaf interchange with Hardin Valley Road, which provides access to Pellissippi State Community College. The Pellissippi Parkway then has another partial cloverleaf interchange with SR 131 (Lovell Road). A short distance later, the controlled access section begins at a partial cloverleaf interchange with Dutchtown Road. Here, the Pellissippi Parkway enters the western end of the city of Knoxville and is paralleled on both sides by frontage roads south for about 1 mile (2 km) to a large interchange with I 40 and I 75. This interchange is a near complete cloverleaf interchange, with three loop ramps and a flyover ramp from the southbound lanes of the parkway to eastbound I 40/northbound I 75, which head concurrently toward downtown Knoxville.

When Oak Ridge was established by the federal government in 1942 for the uranium enrichment operations of the Manhattan Project, SR 62 became the main route between Oak Ridge and Knoxville. After the completion of the adjoining section of I 40/I 75 in 1961, Oak Ridge officials began pushing for a connector route to the Interstate to improve access between Oak Ridge and Knoxville, citing inadequacies in the two lane stretch of SR 62. During the planning phase, a decision was made to have the route terminate with SR 62 at Solway. The new bridge over the Clinch River would then replace the two lane bridge on SR 62 in a separate project. Other alignments would have had the route terminate at I 40/75 near the interchanges with SR 131 and Cedar Bluff Road, respectively. which was subsequently recognized by the Tennessee General Assembly on March 15, 1976. Local officials and residents in 1968 and 1969 unsuccessfully tried to pressure the Tennessee Department of Highways, the predecessor agency to the Tennessee Department of Transportation (TDOT), to construct the route as a fully controlled access highway, but they chose a limited access design that incorporated both interchanges and at grade intersections. Work on the first section, located between I 40/I 75 and Hardin Valley Road, began in June 1970 and was completed in late 1972. This section was accessed via a partial Y interchange along I 40/I 75 adjacent to the interchange with Mabry Hood Road; the Pellissippi Parkway was only accessible from the westbound lanes of the Interstate, and only the eastbound Interstate lanes were accessible from the Pellissippi Parkway. The section between Hardin Valley Road and SR 62 in Solway was completed in late 1973, after months of delays caused by rain. The highway was dedicated by Governor Winfield Dunn on May 31, 1974.

Although intended to initially improve access to Oak Ridge, the Pellissippi Parkway was envisioned from the start to be eventually extended from I 40/I 75 to US 129 in Alcoa in order to provide more efficient access to McGhee Tyson Airport. State plans for extending the Pellissippi Parkway first appeared in a 1973 statewide transportation program, and in April 1975, the Tennessee General Assembly passed a resolution authorizing TDOT to study the possibility of extending the route to US 129. Then Governor Lamar Alexander included the extension as part of a plan to develop a science and technology corridor in the region in the early 1980s. The extension was subject to strong opposition from some locals. In 1982 a group of local residents opposed to the extension formed the Citizens against the Pellissippi Parkway Extension (CAPPE). They charged that the route would pollute the groundwater and streams in the area and that disruptions to streams would create conditions that could result in widespread flooding. They also expressed concern that the roadbed would likely be plagued by geological problems due to large numbers of sinkholes and unstable geological formations in the area. In addition, some critics alleged that Alexander, who is from Maryville, was pushing the extension for his personal financial benefit, citing land he co owned nearby. Alexander denied these allegations—stating that he purchased the land for preservation, not development—and pointed out that the extension had been proposed since before his Governorship began. This route had been determined to circumvent all dangerous sinkholes and caves and was judged to have the least detrimental environmental impact. The extension was one of six freeway projects under this program, dubbed "Bicentennial Parkways", and was initially expected to cost $151.7 million (equivalent to $ in ). but not allowed to be signed until it was linked to I 40/75. On December 18, 1986, a group of landowners submitted a request to TDOT for an interchange with Tooles Bend Road, but this was rejected on October 27, 1988, after several local residents and the Knox County Commission had expressed opposition earlier that year. Construction on the extension began in January 1987, with work on the Tennessee River bridge piers. The bridge was completed in the autumn of 1989 but not opened to traffic; as a result, it faced multiple acts of trespassing and vandalism afterwards. The short segment between Wrights Ferry Road and the Tennessee River was let in May 1988 and completed in August 1990 but also not opened to traffic. and eight months later, work began on the section between the river and SR 332. On December 4, 1992, the 6.6 mile (11 km) segment between US 129 in and SR 332 opened. The next segment completed was the 4 mile (6 km) segment between SR 332 and US 11/US 70 (Kingston Pike), which was contracted in November 1990 and opened on October 6, 1993. This segment was constructed on the former location of the Mabry Hood House, an antebellum home located on Kingston Pike that was demolished in 1983 after falling into disrepair. The contract for the last major section of the extension, located between Kingston Pike and I 40/I 75, was awarded in September 1993 and included construction of part of the interchange with I 40/75. After repeated delays, this section opened on December 16, 1996, along with four ramps connecting to I 40/75, one of which was temporary. At this time, an uninterrupted access controlled connection between the extension and original parkway did not yet exist, requiring traffic north of I 40/75 to enter what was the original parkway connection to I 40/75 via a temporary at grade intersection. The final phase, which began in June 1995 and was completed in late 1998, after multiple delays, completed the interchange with I 40/75 and constructed new carriageways from this interchange to north of Dutchtown Road, replacing the at grade intersection. As part of this project, the flyover ramp from the southbound lanes of the parkway was rebuilt, nearby frontage roads were modified, the at grade intersection with Dutchtown Road was converted into an interchange, and the nearby Mabry Hood Road interchange on I 40/75 was removed.

Although the initial plan was to extend the Pellissippi Parkway to US 129, a concept for extending the route to US 321 (Lamar Alexander Parkway) near Walland has existed since March 1977, when Blount County, Maryville, and Alcoa officials jointly requested funding for the then proposed extension from the Tennessee General Assembly. but was removed by Governor Alexander two months later, who stated that it would not be included in any proposals during his administration. After Alexander left office the following year, the extension began to be listed as a long term plan and was first added to the Knoxville Regional Transportation Planning Organization's long range transportation plan in 1995. Work on the next section, located between Cusick Road and SR 33, began in November 2000 and was completed on August 15, 2005. The final section is a proposed 4.4 mile (7 km) extension past SR 33 to US 321, which would include an interchange with US 411. This final section has been met with much controversy and opposition from locals, causing multiple delays, redesigns, and court reviews. On June 7, 2002, a group of local citizens, who had reorganized Citizens Against the Pellissippi Parkway Extension (CAPPE), filed a lawsuit against TDOT, the FHWA, and the U. S. Department of Transportation, arguing that the FONSI violated provisions of the National Environmental Policy Act that require an environmental impact statement. On July 17, Judge Todd J. Campbell of the U. S. District Court for the Middle District of Tennessee issued an injunction against TDOT, prohibiting them from proceeding with construction activities. On August 29, the FHWA notified TDOT that they were withdrawing the FONSI, but this action was blocked by the District Court on October 1, due to TDOT's intent to proceed with the project without federal funding. The draft environmental impact statement was approved on April 14, 2010. On July 27, 2013, TDOT announced that the alignment for the extension, which includes a westward shift of the southern end from the original plan, had been chosen. and the FHWA approved the route on August 31, 2017. This extension, which TDOT is not expected to be able to begin construction on until at least 2025, has continued to be met with fierce community opposition, however.

On September 7, 1997, the bridge over the Tennessee River was dedicated as the Alexander "Sandy" Bonnyman Medal of Honor Memorial Bridge in honor of a United States Marine Corps officer who was killed in action in the Battle of Tarawa during World War II. Between December 2, 2009, and June 30, 2010, the southbound on ramp from SR 131 was lengthened and straightened, which required closing the ramp to all traffic and widening of the overpass, removing a hazardous accident prone merge with the parkway. In June 2020, work began to modify the interchange with Hardin Valley Road by lengthening and straightening the ramps, adding turn lanes to the ramps, removing an intersection with the northbound ramps, placing a concrete island between the on and off ramps, and adding a new northbound entrance ramp from Hardin Valley Road westbound. The project was completed in January 2022.

The Pellissippi Parkway, alongside other landmarks throughout Eastern Tennessee, derives its name from an older name for the Clinch River. The name "Pelisipi River" was present on older maps with such variant spellings as "Pelisippi" and "Pellissippi", and the variant form "Fiume Pelissipi". In fact, the Mitchell Map (1755–1757) labels a tributary of the "Pelisipi River" as "Clinch's River". The word "Pellissippi" was long said to have been the Cherokee name for the river and was purported to mean "winding waters" in the Cherokee language. However, research completed in 2017 instead concludes that the Miami Illinois name Mosopeleacipi ("river of the Mosopelea" tribe) was first applied to what is now called the Ohio River. Shortened in the Shawnee language to pelewa thiipi, spelewathiipi, or peleewa thiipiiki, the name evolved through other variant forms, such as "Polesipi", "Peleson", "Pele Sipi", and "Pere Sipi", and eventually stabilized to the "Pelisipi/Pelisippi/Pellissippi" form; these names were variously applied back and forth between the Ohio and Clinch rivers.