Винтовка Colt AR-15: Устройство и Принцип Работы

the firearm produced by Colt

The Colt AR 15 is a lightweight, magazine fed, gas operated semi automatic rifle. It is a semi automatic version of the M16 rifle sold for the civilian and law enforcement markets in the United States. The AR in AR 15 stands for ArmaLite rifle, after the company that developed it in the 1950s. Colt's Manufacturing Company currently owns the AR 15 trademark, which is used exclusively for its line of semi automatic AR 15 rifles.

describes the cycling mechanism used in the original AR 15. The bolt carrier acts as a movable cylinder and the bolt itself acts as a piston. This mechanism is often called "direct gas impingement", although that is now considered to be a misconception. The mechanism is now referred to as an "internal gas piston operating system". Gas is tapped from the barrel as the bullet moves past a gas port located above the rifle's front sight base. The gas expands into the port and down a gas tube, located above the barrel that runs from the front sight base into the AR 15's upper receiver. Here, the gas tube protrudes into a "gas key" (bolt carrier key), which accepts the gas and funnels it into the bolt carrier. At this point, the bolt is locked into the barrel extension by locking lugs, so the expanding gas forces the bolt carrier backward a short distance. As the bolt carrier moves toward the butt of the gun, the bolt cam pin, riding in a slot on the bolt carrier, forces the bolt to rotate and thus unlocks it from the barrel extension. Once the bolt is fully unlocked, it begins its rearward movement along with the bolt carrier. The bolt's rearward motion extracts the empty cartridge case from the chamber. As soon as the neck of the case clears the barrel extension, the bolt's spring loaded ejector forces it out the ejection port in the side of the upper receiver. Behind the bolt carrier is a plastic or metal buffer, which rests in line with a return spring. The buffer spring begins to push the bolt carrier and bolt back toward the chamber once it is compressed sufficiently. A groove machined into the upper receiver guides the bolt cam pin and prevents it and the bolt from rotating into a closed position. The bolt's locking lugs push a fresh round from the magazine as the bolt moves forward. The round is guided by feed ramps into the chamber. As the bolt's locking lugs move past the barrel extension, the cam pin twists into a pocket milled into the upper receiver. This twisting action follows the groove cut into the carrier and forces the bolt to twist and "lock" into the barrel extension.

The upper receiver incorporates the hand guard, the charging handle, the forward assist, the gas operating system, the barrel, the bolt and bolt carrier assembly. AR 15s employ a modular design. Thus one upper receiver can quickly and easily be substituted for another. Upper receivers are available with barrels of different weights, lengths, calibers, and rail systems with various sights and accessories. The standard AR 15 rifle uses a barrel. Although, both shorter carbine barrels and longer target barrels are also available. Early models had barrels with a 1:12 rate of twist for the original .223 Remington, bullets. Current models have barrels with a 1:9 or 1:7 twist rate for the 5.56×45mm NATO, bullets.

The lower receiver incorporates the magazine well, the pistol grip, the buttstock, the buffer and the buffer spring. The lower receiver also contains the trigger, disconnector, hammer and fire selector (collectively known as the fire control group). Full sized rifles use a fixed buttstock, while carbines generally use an adjustable telescoping buttstock. The early commercial SP 1 AR 15s used a pair of diameter receiver push pins, identical to those found on the military rifles. In 1966 the company replaced the front pin with a paired nut and screw hinge using a pin to prevent shooters from being able to change receivers with military rifles or competitor rifles without the use of an adapter. They resumed production with the smaller and standardized 0.250 inch pin in the mid 1990s.

The AR 15's most distinctive ergonomic feature is the carrying handle and rear sight assembly on top of the receiver. This is a by product of the original ArmaLite design, where the carry handle served to protect the charging handle. As the line of sight is over the bore, the AR 15 has an inherent parallax problem. At closer ranges (typically inside 15–20 meters), the shooter must compensate by aiming high to place shots where desired. The standard AR 15 rifle has a sight radius. The AR 15 uses an L type flip, aperture rear sight and it is adjustable with two settings, 0 to 300 meters and 300 to 400 meters. The front sight is a post adjustable for elevation. The rear sight can be adjusted for windage. The sights can be adjusted with a bullet tip or pointed tool. The AR 15 can also mount a scope on the carrying handle. With the advent of the AR 15A2, a new fully adjustable rear sight was added, allowing the rear sight to be dialed in for specific range settings between 300 and 800 meters and to allow windage adjustments without the need of a tool or cartridge. Current versions such as AR 15A4 have a detachable carrying handle and use Picatinny rails, which allows for the use of various scopes and sighting devices.

Colt AR 15 rifles most often have a barrel threaded in 1/2″ 28 threads to incorporate the use of a muzzle device such as a flash suppressor, sound suppressor or muzzle brake. The initial design, the "duckbill," had three tines or prongs and was prone to breakage and getting entangled in vegetation. The design was later changed to close the end to avoid this problem. Eventually, on the A2 version of the rifle, the bottom port was closed to reduce muzzle climb and prevent dust from rising when the rifle was fired in the prone position. For these reasons, the US military declared this muzzle device a compensator, but it is more commonly known as the "GI", "A2", or "Birdcage" muzzle device. The standard AR15 muzzle device conforms to the STANAG dimensional requirements for firing 22 mm rifle grenades.

The Colt AR 15 uses 20 or 30 round staggered column detachable box magazines. Low capacity 5 or 10 round magazines are also available to comply with legal restrictions, for hunting, for benchrest shooting or where a larger magazine can be inconvenient.

The primary distinction between civilian semi automatic rifles and military models is select fire. Military rifles were produced with firing modes, semi automatic fire and either fully automatic fire mode or burst fire mode, in which the rifle fires three rounds in succession when the trigger is depressed. Most components are interchangeable between semi auto and select fire rifles including magazines, sights, upper receiver, barrels and accessories. The military M4 carbine typically uses a barrel. Civilian rifles commonly have 16 inch or longer barrels to comply with the National Firearms Act. In order to prevent a civilian semi automatic AR 15 from being readily converted for use with the select fire components, Colt changed a number of features. Parts changed include the lower receiver, bolt carrier, hammer, trigger, disconnector, and safety/mode selector. The semi automatic bolt carrier has a longer lightening slot to prevent the bolt's engagement with an automatic sear. Due to a decrease in mass the buffer spring is heavier. On the select fire version, the hammer has an extra spur which interacts with the additional auto sear that holds it back until the bolt carrier group is fully in battery, when automatic fire is selected. Using a portion of the select fire parts in a semi automatic rifle will not enable a select fire option. As designed by Colt the pins supporting the semi auto trigger and hammer in the lower receiver are larger than those used in the military rifle to prevent interchangeability between semi automatic and select fire components.

After Colt's patents expired in 1977, other manufacturers began to copy the design of the Colt AR 15. The term "AR 15" is a Colt registered trademark which it uses only to refer to its line of semi automatic rifles. Other manufacturers marketed generic AR 15s under other designations, frequently referred to as AR 15s, as are some rifles and carbines not based on the AR 15 design. AR 15 style rifles are available in a wide range of configurations and calibers from a large number of manufacturers. These configurations range from standard full size rifles with 20 inch barrels, to short carbine length models with 16 inch barrels, adjustable length stocks and optical sights, to long range target models with 24 inch barrels, bipods and high powered scopes. These rifles may also have short stroke gas piston system, forgoing the direct gas system standard in AR 15 rifles. These calibers include 5.56×45mm NATO, 5.7×28mm, 6.8mm Remington SPC, .300 Blackout, 9×19mm Parabellum and .458 SOCOM to name a few.

The Colt AR 15 is banned by name in California with a list of additional AR style and AK style firearms in the Kasler v. Lockyer Assault Weapons List. This list deems the Colt AR 15, as well as the Armalite AR 15, Bushmaster XM 15, DPMS Panther, and many other AR pattern rifles as assault weapons by name, thus illegal to own/possess in the state of California. New Jersey passed its own assault weapon ban in 1990, becoming the second state to ban the firearm by name after California. New Jersey's ban also included any firearm with similar functional or cosmetic features, and many toys and imitations that are aesthetically similar. This legislation is still standing as of March 2023 (with additions to the ban over time). Connecticut passed its original assault weapon ban in 1993, becoming the third state to ban the firearm by name. The Federal Assault Weapons Ban was passed by Congress on August 25, 1994, largely mirroring the more restrictive aspects of the legislation found in the three preceding state level bans. This was a 10 year ban on many firearms by name, including the Colt AR 15. The ban expired on September 13, 2004, in accordance with its sunset clause (which required satisfactory evidence of a positive impact on crime for renewal of the ban). While the aforementioned federal ban was still active, four states followed suit with assault weapon bans of their own (including Maryland). One state enacted this legislation after the federal ban's expiry. Two states have also enacted restrictions on ownership without specific bans thereof. Washington, D. C., also has an effective ban on the ownership and possession of the Colt AR 15.