W86

the polyhedron

The W86 was an American earth penetrating ("bunker buster") nuclear warhead, intended for use on the Pershing II intermediate range ballistic missile (IRBM). The W86 design was canceled in September 1980 when the Pershing II missile mission shifted from destroying hardened targets to targeting soft targets at greater range. The W85 warhead, which had been developed in parallel with the W86, was used for all production Pershing II missiles. Development work for the W86's penetrator case began in 1975 at Sandia National Laboratories. The weapon was intended to allow for the destruction of hardened structures and the cratering of runways while using smaller yields.

The warhead was developed from Los Alamos nuclear artillery shell technologies. A 2005 study by the National Research Council that examined a number of nuclear earth penetrating weapon proposals, described the W86 as being in diameter and weighing The study calculated that such an EPW could penetrate into medium strength rock, into low strength rock and into silt or clay, assuming a peak allowable deceleration of The study cites the classified Sandia development report for the W86 warhead for its figures. In the National Research Council study, they refer to the "low yield weapon" (W86) as having a yield of less than or less than
A 1979 article in Sandia's monthly Lab News magazine describes a test unit penetrating 67.5 feet (21 m) into the Tonopah Test Range lake bed, striking the ground at Development called for approximately 20 tests of the penetrator into various mediums. The weapon was an implosion type weapon.