Геохимия: Химиялық талдау арқылы геологиялық жүйелерді зерттеу

Science that applies chemistry to analyze geological systems

Geochemistry is the science that uses the tools and principles of chemistry to explain the mechanisms behind major geological systems such as the Earth's crust and its oceans. However, for the rest of the century the more common term was "chemical geology", and there was little contact between geologists and chemists. The composition of meteorites was investigated and compared to terrestrial rocks as early as 1850. In 1901, Oliver C. Farrington hypothesised that, although there were differences, the relative abundances should still be the same. In the early 20th century, Max von Laue and William L. Bragg showed that X ray scattering could be used to determine the structures of crystals. In the 1920s and 1930s, Victor Goldschmidt and associates at the University of Oslo applied these methods to many common minerals and formulated a set of rules for how elements are grouped. Goldschmidt published this work in the series Geochemische Verteilungsgesetze der Elemente [Geochemical Laws of the Distribution of Elements]. The research of Manfred Schidlowski from the 1960s to around the year 2002 was concerned with the biochemistry of the Early Earth with a focus on isotope biogeochemistry and the evidence of the earliest life processes in Precambrian.

The building blocks of materials are the chemical elements. These can be identified by their atomic number Z, which is the number of protons in the nucleus. An element can have more than one value for N, the number of neutrons in the nucleus. The sum of these is the mass number, which is roughly equal to the atomic mass. Atoms with the same atomic number but different neutron numbers are called isotopes. A given isotope is identified by a letter for the element preceded by a superscript for the mass number. For example, two common isotopes of chlorine are 35Cl and 37Cl. There are about 1700 known combinations of Z and N, of which only about 260 are stable. However, most of the unstable isotopes do not occur in nature. In geochemistry, stable isotopes are used to trace chemical pathways and reactions, while radioactive isotopes are primarily used to date samples. In the Earth's mantle, the primary source of chemical differentiation is partial melting, particularly near mid ocean ridges. This can occur when the solid is heterogeneous or a solid solution, and part of the melt is separated from the solid. The process is known as equilibrium or batch melting if the solid and melt remain in equilibrium until the moment that the melt is removed, and fractional or Rayleigh melting if it is removed continuously. Isotopic fractionation can have mass dependent and mass independent forms. Molecules with heavier isotopes have lower ground state energies and are therefore more stable. As a result, chemical reactions show a small isotope dependence, with heavier isotopes preferring species or compounds with a higher oxidation state; and in phase changes, heavier isotopes tend to concentrate in the heavier phases. Mass dependent fractionation is largest in light elements because the difference in masses is a larger fraction of the total mass. Ratios between isotopes are generally compared to a standard. For example, sulfur has four stable isotopes, of which the two most common are 32S and 34S. In a type of model called a box model, a reservoir is represented by a box with inputs and outputs.]] The composition of the solar system is similar to that of many other stars, and aside from small anomalies it can be assumed to have formed from a solar nebula that had a uniform composition, and the composition of the Sun's photosphere is similar to that of the rest of the Solar System. The composition of the photosphere is determined by fitting the absorption lines in its spectrum to models of the Sun's atmosphere. By far the largest two elements by fraction of total mass are hydrogen (74.9%) and helium (23.8%), with all the remaining elements contributing just 1.3%. There is a general trend of exponential decrease in abundance with increasing atomic number, although elements with even atomic number are more common than their odd numbered neighbors (the Oddo–Harkins rule). Compared to the overall trend, lithium, boron and beryllium are depleted and iron is anomalously enriched. The pattern of elemental abundance is mainly due to two factors. The hydrogen, helium, and some of the lithium were formed in about 20 minutes after the Big Bang, while the rest were created in the interiors of stars. Most of our direct information on the composition of the giant planets is from spectroscopy. Since the 1930s, Jupiter was known to contain hydrogen, methane and ammonium. In the 1960s, interferometry greatly increased the resolution and sensitivity of spectral analysis, allowing the identification of a much greater collection of molecules including ethane, acetylene, water and carbon monoxide. However, Earth based spectroscopy becomes increasingly difficult with more remote planets, since the reflected light of the Sun is much dimmer; and spectroscopic analysis of light from the planets can only be used to detect vibrations of molecules, which are in the infrared frequency range. This constrains the abundances of the elements H, C and N. and the final mission of the Cassini probe in 2017 was to enter the atmosphere of Saturn. In the atmosphere of Jupiter, He was found to be depleted by a factor of 2 compared to solar composition and Ne by a factor of 10, a surprising result since the other noble gases and the elements C, N and S were enhanced by factors of 2 to 4 (oxygen was also depleted but this was attributed to the unusually dry region that Galileo sampled). Outside the core, Jupiter has a mantle of liquid metallic hydrogen and an atmosphere of molecular hydrogen and helium. Metallic hydrogen does not mix well with helium, and in Saturn, it may form a separate layer below the metallic hydrogen. Direct information on Mars, Venus and Mercury largely comes from spacecraft missions. Using gamma ray spectrometers, the composition of the crust of Mars has been measured by the Mars Odyssey orbiter, the crust of Venus by some of the Venera missions to Venus, Additional information on Mars comes from meteorites that have landed on Earth (the Shergottites, Nakhlites, and Chassignites, collectively known as SNC meteorites). Abundances are also constrained by the masses of the planets, while the internal distribution of elements is constrained by their moments of inertia. The compositions of the planets and the Moon are chondritic, meaning that within each group the ratios between elements are the same as in carbonaceous chondrites. The other determining factor, namely the physical conditions attending consolidation, plays, on the whole, a smaller part, yet is by no means negligible. Certain minerals are practically confined to deep seated intrusive rocks, e. g., microcline, muscovite, diallage. Leucite is very rare in plutonic masses; many minerals have special peculiarities in microscopic character according to whether they crystallized in depth or near the surface, e. g., hypersthene, orthoclase, quartz. There are some curious instances of rocks having the same chemical composition, but consisting of entirely different minerals, e. g., the hornblendite of Gran, in Norway, which contains only hornblende, has the same composition as some of the camptonites of the same locality that contain feldspar and hornblende of a different variety. In this connection, we may repeat what has been said above about the corrosion of porphyritic minerals in igneous rocks. In rhyolites and trachytes, early crystals of hornblende and biotite may be found in great numbers partially converted into augite and magnetite. Hornblende and biotite were stable under the pressures and other conditions below the surface, but unstable at higher levels. In the ground mass of these rocks, augite is almost universally present. But the plutonic representatives of the same magma, granite, and syenite contain biotite and hornblende far more commonly than augite.

Trace metals readily form complexes with major ions in the ocean, including hydroxide, carbonate, and chloride and their chemical speciation changes depending on whether the environment is oxidized or reduced. Benjamin (2002) defines complexes of metals with more than one type of ligand, other than water, as mixed ligand complexes. In some cases, a ligand contains more than one donor atom, forming very strong complexes, also called chelates (the ligand is the chelator). One of the most common chelators is EDTA (ethylenediaminetetraacetic acid), which can replace six molecules of water and form strong bonds with metals that have a plus two charge. With stronger complexation, lower activity of the free metal ion is observed. One consequence of the lower reactivity of complexed metals compared to the same concentration of free metal is that the chelation tends to stabilize metals in the aqueous solution instead of in solids. Within aquatic environments, cadmium(II) can either be in the form CdCl+(aq) in oxic waters or CdS(s) in a reduced environment. Thus, higher concentrations of Cd in marine sediments may indicate low redox potential conditions in the past. For copper(II), a prevalent form is CuCl+(aq) within oxic environments and CuS(s) and Cu2S within reduced environments. The reduced seawater environment leads to two possible oxidation states of copper, Cu(I) and Cu(II). Trace metals with nutrient type distributions are strongly associated with the internal cycles of particulate organic matter, especially the assimilation by plankton. The lowest dissolved concentrations of these metals are at the surface of the ocean, where they are assimilated by plankton. As dissolution and decomposition occur at greater depths, concentrations of these trace metals increase. Residence times of these metals, such as zinc, are several thousand to one hundred thousand years. Finally, an example of a scavenged type trace metal is aluminium, which has strong interactions with particles as well as a short residence time in the ocean. The residence times of scavenged type trace metals are around 100 to 1000 years. The concentrations of these metals are highest around bottom sediments, hydrothermal vents, and rivers. For aluminium, atmospheric dust provides the greatest source of external inputs into the ocean. Iron and copper show hybrid distributions in the ocean. They are influenced by recycling and intense scavenging. Iron is a limiting nutrient in vast areas of the oceans and is found in high abundance along with manganese near hydrothermal vents. Here, many iron precipitates are found, mostly in the forms of iron sulfides and oxidized iron oxyhydroxide compounds. Concentrations of iron near hydrothermal vents can be up to one million times the concentrations found in the open ocean. Using electrochemical techniques, it is possible to show that bioactive trace metals (zinc, cobalt, cadmium, iron, and copper) are bound by organic ligands in surface seawater. These ligand complexes serve to lower the bioavailability of trace metals within the ocean. For example, copper, which may be toxic to open ocean phytoplankton and bacteria, can form organic complexes. The formation of these complexes reduces the concentrations of bioavailable inorganic complexes of copper that could be toxic to sea life at high concentrations. Unlike copper, zinc toxicity in marine phytoplankton is low and there is no advantage to increasing the organic binding of Zn2+. In high nutrient, low chlorophyll regions, iron is the limiting nutrient, with the dominant species being strong organic complexes of Fe(III).