Одноточечная развязка: проектирование и преимущества

Highway interchange design

A single point urban interchange (SPUI, '/s//p//uː//i/ or '/s//p//juː//i/ ), also called a single point interchange (SPI) or single point diamond interchange (SPDI), is a type of highway interchange. The design was created in order to help move large volumes of traffic through limited amounts of space efficiently.

A SPUI is similar in form to a diamond interchange but has the advantage of allowing opposing left turns to proceed simultaneously by compressing the two intersections of a diamond into one single intersection over or under the free flowing road. The term "single point" refers to the fact that all through traffic on the arterial street, as well as the traffic turning left onto or off the interchange, can be controlled from a single set of traffic signals. Due to the space efficiency of SPUIs relative to the volume of traffic they can handle, the interchange design is being used extensively in the reconstruction of existing freeways as well as constructing new freeways, particularly in dense urban environments. Sometimes a SPUI will allow traffic to proceed straight through from the offramp to the onramp; this usually happens when the ramps connect with frontage roads. Since most through traffic travels over or under the intersection, the SPUI is still much more efficient than a surface intersection.

The most commonly cited advantages of SPUIs are improved operation efficiency and safety as well as reduced right of way requirements compared to other interchange forms. Left turning traffic from both directions of the intersecting roadways are able to turn simultaneously without crossing the path of the opposing left turns. Because traffic passing through the interchange can be controlled by a single signal, vehicles can clear the intersection much more quickly than in a diamond interchange (which requires two sets of traffic signals). SPUIs also allow for wider turns, easing movement for large vehicles, such as trucks and RVs. Furthermore, a SPUI takes up considerably less space than a full cloverleaf interchange, allowing construction to take place on a limited amount of property and minimizing state use of eminent domain. Finally, SPUIs are reportedly safer than other space efficient interchange forms, such as (standard) diamond interchanges. Research suggests that, although there may not be a significant difference between the two types of interchanges in terms of total collisions, the injury and fatality rates are notably lower for SPUIs than diamond interchanges.

The major disadvantage of SPUIs over other types of road junctions is the increased cost due to the need for a longer or wider bridge. A freeway under SPUI (as in the upper diagram) requires a wider bridge over the free flowing road to make room for the compressed on and off ramps. However, this disadvantage poses less of a problem in cases where the arterial, or nonfreeway road, already requires a very wide bridge. The intersection of 97 Street, having 7 throughlanes, with Yellowhead Trail in Edmonton, Alberta, Canada, though a diamond interchange in concept, required such a wide bridge that traffic signal phasing allows this intersection to behave as a SPUI. A freeway over SPUI (as in the lower photo) requires a longer bridge of the free flowing road to cross the wider area required for the SPUI intersection below. Because vehicles must be able to cross the pavement in 6 different ways, a SPUI generally has a very large area of uncontrolled pavement in the middle of the intersection. This can be unsafe particularly if drivers are unfamiliar with the interchange type. Drivers making a left turn may become confused as oncoming turning traffic passes them on the righthand side. Due to the large intersection area, the traffic lights need a longer yellow and red phase to clear the intersection, and, even then, it mayn’t be long enough for a bicyclist entering on green or yellow to make it across before opposing traffic gets a green. Pedestrians are usually not able to get through the intersection with a green light. It can take up to 4 cycles to walk through the entire length of a SPUI. Several SPUIs, built in the 1970s and later, are located on German autobahns, like the A40, A42, A44, A46, A57, A59, and A113 in Berlin. There is also a SPUI on the Frankenschnellweg, the urban part of the A73, and Maximilianstraße, in Nuremberg (at ). Smaller versions of the SPUI can also be found on non autobahn roads in German cities, with right turning traffic under signal control, located in Heilbronn, Karlsruhe, Sindelfingen, Stuttgart, and Wiesbaden. SPUIs are also found in Australia, Canada, Hong Kong, Indonesia, and Singapore.

A rarely built variant of the SPUI is the inverted SPUI, in which the carriageways of the free flowing road are separated, with left on and offramps running between the carriageways and coming to a single at grade intersection with the cross street. This can be built less expensively than a standard SPUI by allowing for shorter, simpler bridges at the interchange. However, this inverts the usual convention of placing carriageway on and offramps on the right side of the carriageway, instead placing them on the left side, usually considered the passing lane.

Interstate 290 in Oak Park, Illinois, near Chicago, at South Harlem Avenue and at South Austin Boulevard Greensboro, North Carolina, connecting West Wendover Avenue to South Holden Road Interstate 244 in Tulsa, Oklahoma, at Sheridan Road and at Memorial Drive U. S. Route 422 in Reading, Pennsylvania, at U. S. Route 222 Business State Route 18 in St. George, Utah, at Red Hills Parkway. Woodall Rogers Freeway (TX Spur 366), in Dallas, Texas at Riverfront Boulevard, immediately before the Margaret Hunt Hill Bridge .

There is also a variant of the inverted SPUI, which can be used when a side road ends at, rather than crossing, a free flowing road. In this variant, one carriageway of the free flowing road is grade separated from the side road, as with a typical inverted SPUI, while the other carriageway of the free flowing road is at grade with but still separated from the side road, as found in a continuous green T (or seagull) intersection. There is one such interchange in Pultney Township, Belmont County, Ohio, between State Route 7 (SR 7) and Interstate 470 (I 470) at The ramps leading to and from I 470 run west of, but are not directly connected to, SR 7; these ramps form the "side road" at this interchange. The southbound carriageway of SR 7 bridges over the interchange, while its northbound carriageway remains at grade. SR 7's left on and offramps run between its carriageways, meeting the I 470 ramps at an at grade intersection. The I 470 ramps proceed to a trumpet interchange with I 470. I 470 itself bridges over both carriageways of SR 7 a short distance north of the I 470/SR 7 ramps' intersection. This design was likely chosen not for cost savings but because the northbound carriageway of SR 7 is bordered by railroad tracks, commercial properties, and the Ohio River and because I 470 bridges the river just east of SR 7—a more conventional interchange design was likely more difficult to achieve. There is another such interchange in Millvale, Pennsylvania, near Pittsburgh, at the junction between Pennsylvania Route 28 (PA 28) and the 40th Street Bridge. The northbound carriageway of PA 28 passes under the interchange, with lefthand ramps meeting at the bridge (the northbound entrance ramp does not provide direct access to PA 28). The southbound carriageway of PA 28 has a continuous green T intersection with the bridge. A similar interchange exists in Coal Grove, Ohio, at the junction of U. S. Route 52 (US 52) with the Ben Williamson Memorial Bridge and the Simeon Willis Memorial Bridge, which cross the Ohio River and lead to and from Ashland, Kentucky, respectively. The eastbound carriageway of US 52 passes under the interchange, with lefthand exit and entrance ramps to the bridges. The westbound carriageway of US 52, which narrows to one throughlane, has a continuous green T intersection with the bridges. The ramps cross each other at grade, with a traffic light controlled intersection. An interchange, like that in Millvale, Pennsylvania, formerly existed at the junction of SR 7 and SR 822 at the now demolished Fort Steuben Bridge in Steubenville, Ohio. The northbound carriageway of SR 7 passed under the bridge, with lefthand ramps meeting the bridge approach, while the southbound carriageway had a continuous green T intersection with the bridge.

An offset SPUI is similar to a diamond interchange, however, by making two of the ramps flyovers or flyunders, all ramps are pushed to one side of the highway, where they meet the surface street at a single intersection. An example of this is the interchange between Interstate 225 and Alameda Avenue near the Town Center at Aurora shopping center in Aurora, Colorado, United States (at ).