Разделение печатных плат: методы и оборудование.

Depaneling or depanelization is a process step in high volume electronics assembly production. In order to increase the throughput of printed circuit board (PCB) manufacturing and surface mount (SMT) lines, PCBs are often arranged in a process called panelization so that they consist of many smaller individual PCBs that will be used in the final product. This PCB cluster is called a panel or multiblock. The large panel is broken up or "depaneled" as a certain step in the process depending on the product, it may happen right after SMT process, after in circuit test (ICT), after soldering of through hole elements, or even right before the final assembly of the PCB assembly (PCBA) into the enclosure.

This method is suitable for strain resistant circuits (e. g. without SMD components). The operator simply breaks the PCB, usually along a prepared V groove line, with the help of a proper fixture.

A pizza cutter is a rotary blade, sometimes rotating using its own motor. The operator moves a pre scored PCB along a V groove line, usually with the help of a special fixture. This method is often used only for cutting huge panels into smaller ones. The equipment is cheap and requires only sharpening of the blade and greasing as maintenance. It uses an aluminium based jig to secure the PCB in place.

Punching is a process where single PCBs are punched out of the panel through the use of special fixture. It is a two part fixture, with sharp blades on one part and supports on the other. The production capacity of such a system is high, but fixtures are quite expensive and require regular sharpening.

A depaneling router is a machine similar to wood router. It uses a router bit to mill the material of the PCB. The hardness of the PCB material wears down the bit, which must be replaced periodically. Routing requires that single boards are connected using tabs in a panel. The bit mills the whole material of the tab. It produces much dust that has to be vacuumed. It is important for the vacuum system to be ESD safe. Also the fixturing of the PCB must be tight usually an aluminium jig or a vacuum holding system is used. The two most important parameters of the routing process are: feed rate and rotational speed. They are chosen according to the bit type and diameter and should remain proportional (i. e. increasing feed rate should be done together with increasing the rotational speed). Routers generate vibrations of the same frequency as their rotational speed (and higher harmonics), which might be important if there are vibration sensitive components on the surface of the board. The strain level is lower than for other depaneling methods. Their advantage is that they are able to cut arcs and turn at sharp angles. Their disadvantage is lower capacity.

A saw is able to cut through panels at high feed rates. It can cut both V grooved and not V grooved PCBs. It does not cut much material and therefore generates low amounts of dust. The disadvantages are: ability to cut in straight lines only and higher stress than for routing.

Laser cutting is now being offered as an additional method by some manufacturers. UV laser depaneling makes use of a 355 nm wavelength (ultraviolet), diode pumped, Nd:YAG laser source. At this wavelength the laser is capable of cutting, drilling and structuring on rigid and flex circuit substrates. The laser beam, capable of cut widths under 25 μm, is controlled by high precision, galvo scanning mirrors with repeat accuracy of +/ 4 μm.