Nine-volt battery

Form of small battery

The nine volt battery, or 9 volt battery, is an electric battery that supplies a nominal voltage of 9 volts. Actual voltage measures 7.2 to 9.6 volts, depending on battery chemistry. Batteries of various sizes and capacities are manufactured; a very common size is known as PP3, introduced for early transistor radios. The PP3 has a rectangular prism shape with rounded edges and two polarized snap connectors on the top. This type is commonly used for many applications including household uses such as smoke and gas detectors, clocks, and toys. The nine volt PP3 size battery is commonly available in primary zinc–carbon and alkaline chemistry, in primary lithium iron disulfide and lithium manganese dioxide (sometimes designated CRV9), and in rechargeable form in nickel–cadmium (Ni–Cd), nickel–metal hydride (Ni–MH) and lithium ion. Mercury batteries of this format, once common, have been banned in many countries due to their toxicity. Designations for this format include NEDA 1604 and IEC 6F22 (for zinc carbon) or MN1604 6LR61 (for alkaline). The size, regardless of chemistry, is commonly designated PP3—a designation originally reserved solely for carbon zinc, or in some countries, E or E block. A range of PP batteries was produced in the past, with voltages of 4.5, 6, and 9 volts and different capacities; the larger 9 volt PP6, PP7, and PP9 are still available. A few other 9 volt battery sizes are available: A10 and A29. These cells are slightly smaller than LR8D425 AAAA cells and can be used in their place for some devices, even though they are 3.5 mm shorter. Carbon zinc types are made with six flat cells in a stack, enclosed in a moisture resistant wrapper to prevent drying. Primary lithium types are made with three cells in series. 9 volt batteries accounted for 4% of alkaline primary battery sales in the United States in 2007, and 2% of primary battery sales and 2% of secondary (rechargeable) battery sales in Switzerland in 2008.

Historically, the now popular PP3 battery size was a member of the power pack (PP) battery family that was originally manufactured by Ever Ready in the United Kingdom and Eveready in the United States. The company says that it introduced the PP3 battery in 1956. In the 1940s, 1950s, and 1960s, they were commonly marketed as transistor radio batteries, or TR for short (meant to emulate the function of the old B battery). The PP3 battery was added as an ANSI standard in 1959, currently known as ANSI 1604A. + Power pack (PP) battery family Name Voltage Capacity Depth Width Height PP1 6 volt 4 Ah 55.6 mm 65.1 mm 55.6 mm PP3 9 volt 0.5 Ah 17.5 mm 26.5 mm 48.5 mm PP4 9 volt 0.9 Ah Dia. 25.8 mm, length: 49.8 mm; 41.5 mm ex. contacts PP6 9 volt 1 Ah 34.1 mm 35.7 mm 69.9 mm PP7 9 volt 2.5 Ah 46 mm 46 mm 63 mm PP8 6 volt 15 Ah 55 mm 61 mm 200 mm PP9 9 volt 5 Ah 51.5 mm 65 mm 80 mm PP10 9 volt 15 Ah 66 mm 65 mm 267 mm PP11 4.5 volt × 2 5 Ah 51.5 mm 65 mm 91 mm

The PP11 consists of two isolated 4.5 volt batteries with four terminals. Only the PP3, PP6, PP7 and PP9 sizes are still manufactured, with the PP3 being extremely common. Modern batteries have higher capacities and lower internal resistances than early versions. Before the mid 1950s, in the days of vacuum tube (valve) radios used batteries designed specifically for vacuum tubes, there was a nine volt grid bias battery or (US) "C" battery, which had taps for various voltages from 1.5 to 9 volts. Early transistorized radios and other equipment needed a suitable voltage miniature battery. Early transistor radios required a 22 1/2 volt battery. Although the transistors would theoretically operate from lower voltages, the point contact transistors used in 1954 had to be operated very close to their VCBO limit in order to get the required frequency response. However, a suitable miniature battery was already marketed for (vacuum tube) hearing aids. The PP3 (physically identical to 6LR61 and 1604A) appeared when portable transistor radios became common, and was referred to as a transistor battery or transistor radio battery.

The PP3 battery has both terminals in a snap connector on one end. The smaller circular (male) terminal is positive, and the larger hexagonal or octagonal (female) terminal is the negative contact. The connectors on the battery are the same as on the load device; the smaller one connects to the larger one.

Very often, a "9 volt" battery refers to the transistor radio size called PP3 or IEC 6F22 or NEDA 1604, although there are less common nine volt batteries of different sizes. Batteries of all types are manufactured in consumer and industrial grades. Costlier industrial grade batteries may use chemistries that provide higher power to size ratio, have lower self discharge and hence longer life when not in use, more resistance to leakage and, for example, ability to handle the high temperature and humidity associated with medical autoclave sterilization. Type IECname ANSI/NEDAname Typical capacity(mAh) Typical capacity (Wh) Nominalvoltages Primary(disposable) Alkaline, six cylinder 6LR61 1604A 550 4.95 9 Alkaline, six stack 6LP3146 1604A 550 4.95 9 Zinc–carbon 6F22 1604D 400 3.6 9 Lithium (varies) 1604LC 1200 10.8 9 Rechargeable Ni–Cd 6KR61 11604 120 0.864, 1.008 7.2, 8.4 Ni–MH 6HR61 7.2H5 175–300 1.26 2.16, 1.47 2.52, 1.68 2.88, 7.2, 8.4, 9.6 Lithium polymer (varies) 520 3.848 7.4 Lithium ion (varies) 620 4.588 7.4 Lithium iron phosphate 200–320 1.92 3.072 9.6

Battery chargers are devices that charge batteries, some of which may also be able to charge nine volt batteries. Whether a charger can charge the battery depends largely on the dimensions of the battery and internal chemistry (I. E., disposable batteries cannot be charged). Testing a nine volt battery can be done using a multi meter by probing the voltage across the two terminals. The voltage measured by the multi meter can then be used to roughly assess the charge of the battery. If the positive and negative terminals of the battery are close enough, licking a nine volt battery can be a quick test to check if a battery has any charge left. A tingling sensation can be felt across the tongue depending on the voltage of the battery; The higher the current flowing through the tongue the more intense the tingling sensation. Although largely safe, some people may find the tingling sensation unpleasant.

Lithium 9 volt batteries are disposable high energy density batteries. In the PP3 size they are typically rated at 0.8–1.2 Ah (e. g. >1.2 Ah @ 900 ohms to 5.4 V @ 23 °C for one type), about twice the capacity of alkaline batteries. Some manufacturers claim the energy density can be five times that of alkaline. Common applications for lithium nine volt batteries are smoke and carbon monoxide detectors.