Ағылшыншамен салыстырыңыз: абзацты басыңыз — түпнұсқа терезеде ашылады. Абзац астындағы EN түймесі оны мәтін ішінде көрсетеді.
Кіріспе
Электрондық схема
Electronic circuit
Қос модульді прескалер – жоғары жиілікті синтезаторлардың құрылымында қолданылатын, жүйедегі кері байланыс тізбегі арқылы тікелей өткізілуі мүмкін емес, бірақ өте жақын аралықтағы жоғары жиіліктерді жасау мәселесін шешуге арналған электрондық схема. Прескалердің модулі – оның жиілік бөлігіші. Қос модульді прескалерде әдетте M және M+1 екі бөлек жиілік бөлігіші болады.
A dual modulus prescaler is an electronic circuit used in high frequency synthesizer designs to overcome the problem of generating narrowly spaced frequencies that are nevertheless too high to be passed directly through the feedback loop of the system. The modulus of a prescaler is its frequency divisor. A dual modulus prescaler has two separate frequency divisors, usually M and M+1.
Мысал
Қазіргі кезде көптеген екі модульді прескалерлер PLL чиптерінің ішінде орналасқан, бұл олардың жұмыс істеу кезінде нақты сигналдарын тексеруді қиын етеді. Алғашқы екі модульді прескалерлер PLL чиптерінен бөлек, дискретті ECL құрылғылары болған. Міне, екі модульді прескалердің жұмыс істеуінің мысалы. Бұл схемада Motorola MC145158 және Fujitsu MB 501 екі модульді прескалерлері 128/129 режимінде қолданылады. PLL, 917.94 МГц (fo) жиілігінде, 30 кГц (fr) арналық жиілікпен құлыпталған. Сондықтан, жалғыз бүтін сандардың жалпы саны 30 598-ге тең. Оны 128-ге (M) бөлгенде 239 бөлігі шығады, ал қалдығы 6, N және A болып табылады. Осы жиілік таңдауының нәтижесінде прескалер көп уақытын 128 санауда, ал қысқа мерзімді 129 санауда өткізеді. Бұл жоғарғы күлгін сызықпен, модульді басқару, А, есептегіш шығысы арқылы көрсетілген. Бұл екі скриншот көлденең масштабта ғана ерекшеленеді. Төменгі сары сызық – N есептегіш шығысы, оның жиілігі 30 кГц арналық жиілікке сәйкес келеді. Жасыл сызық – екі модульді прескалердің шығысы, ол прескалер 128 болғанда 7.1714 МГц-ке, ал 129 болғанда 7.1158 МГц-ке сәйкес келеді. Модульді басқарудың прескалер шығысының дәл 6 циклы үшін төмен екендігі анық көрінеді. Бірақ жиілік модульді басқарудың екі күйі арасында бір проценттен де аз өзгеретіні байқалмайды. A = 0 болған жағдайларда, екі модульді прескалер тек 128 еселік санауды жүзеге асырады. Бұл 906.24, 910.08, 913.92, 917.76, 921.60 МГц және т.б. жиіліктерде болады.
Today, most dual modulus prescalers exist inside PLL chips, making it impossible to probe actual signals during operation. The first dual modulus prescalers were discrete ECL devices, separate from the PLL chips. Here is an example of a dual modulus prescaler in use. This circuit happens to use a Motorola MC145158 with a Fujitsu MB 501 dual modulus prescaler operating in the 128/129 mode. The PLL is locked at 917.94 MHz (fo) with a channel spacing frequency of 30 kHz (fr). The total integer count, therefore, is 30,598. Dividing this by 128 (M) yields a quotient of 239 with a remainder of 6, N, and A, respectively. The result of this frequency choice is that the prescaler spends most of its time counting at 128 and just a brief period at 129. This is shown by the upper purple trace, the modulus control, A, counter output. These two screen captures differ only in the horizontal scale. The lower, yellow trace is the N counter output whose frequency corresponds to the channel spacing frequency of 30 kHz. The green trace is the output from the dual modulus prescaler, which happens to correspond to 7.1714 MHz in the case that the prescaler is at 128 and 7.1158 when it is at 129. It is plainly obvious that the modulus control is low for precisely 6 cycles of the prescaler output. What is not obvious is the fact that the frequency changes by less than one percent between the two states of the modulus control. There will be cases where A = 0, resulting in the dual modulus prescaler counting only by 128. This would happen at 906.24, 910.08, 913.92, 917.76, 921.60 MHz, and so on.