Сегментные мосты: пошаговая сборка пролётных конструкций.

Structure meant to span obstacles, assembled one piece at a time

A segmental bridge is a bridge built in short sections (called segments), i. e., one piece at a time, as opposed to traditional methods that build a bridge in very large sections. The bridge is made of concrete that is either cast in place (constructed fully in its final location) or precast concrete (built at another location and then transported to their final location for placement in the full structure). These bridges are very economical for long spans (more than ), especially when access to the construction site is restricted. They are also chosen for their aesthetic appeal.

The first cantilevered segmental cast in place concrete bridge, built in 1930, was de across Rio do Peixe in the state of Santa Catarina of Brazil. It was followed in 1951 by the prestressed concrete bridge across the Lahn River in lt=Balduinstein, Germany, the first of many cantilevered bridges designed by de. The first prestressed concrete bridge, assembled by several precast elements, was the fr across the river Marne in France, built according to the design by Eugène Freyssinet and commenced in 1940, but due to the war, completed only in 1946.

The sequence of construction is similar to traditional concrete bridge building, i. e., build the support towers (columns), build the temporary falsework, build the deck, perform finish work. The principal differences are as follows:
The support towers may be built segmentally. Often this is accomplished using "slip form" construction, where the falsework moves (slips) upward following sequential concrete "pours." The falsework uses the newly constructed concrete as the basis for moving upward. After the towers are built, a superstructure is built atop the towers. This superstructure serves as the "launching" point for building the deck. (The deck is often built in both directions away from the tower, simultaneously.) The deck is now constructed sequentially, beginning at the tower, one section at a time. This process is usually accomplished using a self propelled bridge layer that hoists the bridge section into place. In cast in place bridges, the falsework is connected to the previously installed concrete and allowed to cantilever freely. Next, the permanent reinforcing steel and supports are installed. Finally, the concrete is placed and cured, freeing the falsework to be moved. In pre cast bridges, the concrete segment is constructed on the ground, and then transported and hoisted into place. As the new segment is suspended in place by the crane, workers install steel reinforcing that attaches the new segment to preceding segments. Each segment of the bridge is designed to accept connections from both preceding and succeeding segments. The process in step 3 is repeated until the span is completed.

http://www. fhwa. dot. gov/bridge/segmental/index. htm
http://www. asbi assoc. org/
http://www. figgbridge. com/
http://www. finleyengineeringgroup. com/index. cfm/home
http://www. mcnarybergeron. com/
http://www. pbworld. com/news events/publications/network/issue 57/57 03 murilloj briefhistoryseg. asp
http://www. pbworld. com/news events/publications/network/issue 28/28 16 wahlp constructionsequence. asp
http://www. polito. it/creepanalysis