Бірінші дүниежүзілік соғыстағы француздық истребитель ұшағы

French WW1 fighter aircraft

The Nieuport 17 C.1 (or Nieuport XVII C.1 in contemporary sources) is a French sesquiplane fighter designed and manufactured by the Nieuport company during World War I. An improvement over the Nieuport 11, it was a little larger than earlier Nieuports and better adapted to the more powerful engine than the interim Nieuport 16. Aside from early examples, it had the new Alkan Hamy synchronization gear, permitting the use of a fuselage mounted synchronised Vickers gun firing through the propeller disc. At the time of its introduction in March 1916, the type's outstanding manoeuvrability and excellent rate of climb gave it a significant advantage over fighters on both sides and was described as "the best pursuit plane of the day". It was used by many operators and entered service with every Allied power and copies were also operated by the Deutsche Luftstreitkräfte (German Air Service). Mass produced by several French firms, the Nieuport 17 and its derivatives were built under licence in Italy by Nieuport Macchi and in Russia by Dux. Unlicensed copies, notably the Siemens Schuckert D. I and the Euler D. I, were produced in Germany. The Nieuport 21 and 23 represented relatively minor alterations. Aerodynamic refinement led to the Clerget powered 17bis. More powerful versions of the Le Rhône rotary engines with detail improvements resulted in the Nieuport 24, 24bis and 27.

When Gustave Delage was appointed as the chief designer of Nieuport, in January 1914, a series of sesquiplane designs followed. Nieuport had been famous for wire braced monoplanes and these had reached the limit of their development. The sesquiplane configuration was adopted by Delage as a compromise between the low drag of a monoplane and the greater strength of a biplane. The first of Delage's sesquiplanes was the two seat Nieuport 10 of 1914, which was followed the next year by the smaller Nieuport 11 single seater, which in turn was supplemented by the Nieuport 16. The larger engine of the latter aircraft made it nose heavy and increased the wing loading, especially when armed with a synchronised Vickers gun. Developed in parallel with the conservative Nieuport 16, the Nieuport 17 was slightly larger with longer wings and fuselage, improved aerodynamic form and better balance. It was fitted with the Le Rhône 9J engine and later examples used motors.

The upper wings of the Nieuport sesquiplanes used a typical structure for the period, with widely spaced spars connected with full chord ribs and compression ribs, cross braced internally with wire and by riblets on the leading edge. The lower wing's single spar was directly below the rear spar of the upper wing and was braced with a characteristic Vee strut. The horizontal stabilizer, elevator and rudder were built up from welded diameter steel tube and controls for these were provided via conventional cables and pulleys. The single spar was behind the centre of lift, which at high speeds could cause the lower wing to twist, increasing the angle of attack until the wing stalled, at which point it would return to its normal position, repeating until the wing snapped or the pilot slowed the aircraft. British Nieuports were modified at No 2 Aeroplane Supply Depot to alleviate this problem. Late in French service, some N.17s had their lower wings replaced with spares intended for the newer Nieuport 24. The fuselage of the 17 was built around four ash longerons which tapered from the rectangular sheet steel engine mounting to the rudder post, with the upper longerons bowed around the cockpit, giving most of the fuselage a trapezoid cross section. This was braced with spruce struts held with diagonal bracing wires and steel plate joints. The sides and top of the forward fuselage were covered in light molded plywood panels while the rear fuselage sides were covered in fabric. Behind the pilot was a headrest, molded into the plywood top decking, which was supported by longitudinal stringers. Production of the new Alkan Hamy synchronization gear permitted the wing mounted Lewis gun on the earliest examples to be replaced with a synchronised Vickers gun mounted on the fuselage to fire through the propeller arc.

Entering service in May 1916 but not named until September, the Nieuport 21 differed from the 17 primarily in the adoption of the lower powered Le Rhône 9C or Le Rhône 9Ga engine. This increased endurance and reduced wing loading and was useful for a high altitude bomber escort but it was rarely employed as such. In French and especially Russian service, the 21 was commonly used with the Nieuport 17 in the same general fighter role, although it was also useful as an advanced trainer. The 21 has commonly been mistaken for the earlier Nieuport 11, as both lacked headrests and used the same cowling and engines, particularly when some Nieuport 11s were also fitted with molded fuselage sides. Like the 17, the 21 is larger and can be identified by the flying wires, which restrain the upper wings. On the 11 the flying wires merged to a single point, while on the 21 they ran parallel to different points on the lower fuselage. The Nieuport 23 was largely the same as the definitive 17, differing mainly in the use of a different machine gun synchronizer. The gun was offset to starboard, the fuel and oil tank arrangement and the center section rigging were changed to suit. Nieuport 23s were operated by both French and British squadrons alongside Nieuport 17s until their replacement by the later Nieuport 24, 24bis and 27. The more powerful Clerget 9B nine cylinder rotary engine was used by the Nieuport 17bis, which first appeared late in 1916. The N.17bis had stringers fairing out the fuselage sides compared to the flat sides on the 17. The major user was the British Royal Naval Air Service, which ordered 32 from Nieuport, 50 more being licence built by the Nieuport & General Aircraft Company. Heavier than the preferred Le Rhône, output from the Clerget rotaries quickly fell below their rated power and the performance of the 17bis suffered accordingly. Armament often included a synchronised Vickers gun with the standard over wing Lewis. Related to the 17bis, the Nieuport 23bis combined the aerodynamic improvements of the 17bis but reverted to the Le Rhône. Few were built and the Royal Naval Air Service may have been the sole operator. A pair of triplanes based on the Nieuport 17 were constructed for testing purposes, one for the French and the other for the British. The narrow chord wings were staggered in an unusual manner, placing the middle wing furthest forward and the top wing furthest aft. No subsequent orders came as a result of these tests. Nieuport later trialled the same layout on the Nieuport 17bis, which was tested by the British Royal Flying Corps and Royal Naval Air Service as well, however this also remained a prototype. Several of the experimental Berliner Helicopters, named after their German American inventor Emile Berliner, were manufactured around Nieuport 23 fuselages, including the 1922 and 1923 versions.

During March 1916, the new Nieuport 17 reached the front to begin replacing the earlier Nieuport 11 and 16 fighters that had been instrumental in ending the Fokker Scourge of 1915. On 2 May 1916, Escadrille N.57 became the first unit entirely equipped with the new model. During the late 1916 and into 1917, the Nieuport 17 equipped every fighter squadron of the Aéronautique Militaire. Almost all of the top French aces flew the nimble Nieuport during their flying careers, including Georges Guynemer, Charles Nungesser, Maurice Boyau, Armand Pinsard and René Dorme. American volunteers of the [[Lafayette Escadrille, converted to the Nieuport 17 from Nieuport 11s and 16s, although only one achieved ace status, Raoul Lufberry. The Nieuport 17 was ordered by the Royal Flying Corps and Royal Naval Air Service as it was markedly superior to British fighters. RFC squadrons that used Nieuport 17s and 23s as their main equipment included 1, 11, 29, 40 and 60 squadrons while 1, 3 and 4 Wings of the Royal Naval Air Service operated the 17 and the 17bis. Mick Mannock V. C. flew Nieuports early in his career with 40 Squadron. His VC award reflected his combat career – including his time on Nieuports. The top scoring Nieuport ace was Captain Phillip Fletcher Fullard of No. 1 Squadron RFC, who scored 40 kills between May and October 1917, before breaking his leg in a football match. Italian aces, such as Francesco Baracca, Silvio Scaroni and Pier Piccio, achieved victories while flying Nieuport fighters. In Belgium, the 1st and 5th Belgian escadrilles were equipped with the Nieuport 17 and 23. Belgian aces flying the type included Andre de Meulemeester, Edmond Thieffry and Jan Olieslagers. The Imperial Russian Air Service operated large numbers of Nieuports of all types, including the 17, 21 and 23. Later in its service life, the 17 was operated in large numbers as an advanced trainer. The American Expeditionary Forces purchased 75 Nieuport 17s for training and the French operated a fleet of trainers. The French Aviation Maritime operated one Nieuport 21 for carrier training during 1920 and 1921 aboard Bapaume, a converted French Arras class aviso, pending the delivery of carrier aircraft such as the Nieuport Delage NiD.32RH. Following its retirement from the European theatre, many examples were exported in small numbers for new Air Forces being formed around the world, to be used through the 1920s.

So impressive were the Nieuport fighters in early 1916 that Idflieg (the German Inspectorate of flying troops) requested their aircraft manufacturers to produce a copy. Retrieved aircraft, detailed drawings and sketches were provided and the Siemens Schuckert D. I was produced. The copy differed primarily in minor details, was deemed to be satisfactory and went into production, although the SSW D. I was obsolete by the time it went into service and was used mainly as an advanced trainer. Another clone of the Nieuport 17 was the Euler D. I, although development work did not proceed beyond a few prototypes. Other manufacturers, notably Albatros and Pfalz, explored a sesquiplane configuration in their own fighter designs. The Albatros D. II led to the Albatros D. III and D. V commonly called 'V strutters' by the RFC to distinguish them from the earlier Albatros fighters. As well as the advantages of this layout these types also exacerbated the flutter problem, which was never satisfactorily contained, in spite of strengthening. The Pfalz D. III was also a sesquiplane version of a previous biplane fighter, although it featured a more substantial lower wing with two spars that avoided the flutter problems encountered by single spar sesquiplanes.

A single original example has survived, this being Nieuport 23 "5024", which has been preserved and following a recent restoration, was placed on static display in the Belgian Royal Museum of the Armed Forces and Military History in Brussels. The Nieuport 17 has also become a popular aircraft for replica builders. Dedicated kits for the type have been produced, including both 7/8ths scale and full size, and groups of builders have reproduced entire squadrons of aircraft in this manner. Contemporary drawings, sourced from both the original factory and a German technical report on the fighter, have facilitated the construction of various replicas, such as the example on display in the Canadian War Museum in Ottawa, Ontario, which was built to the original specifications, while many others have used more modern construction, often using metal tubes to replace much of the wooden structure used on authentic aircraft.