Пруссиялық үстінен зарядталатын мылтық

Prussian bolt action rifle

The italic=no needle gun was a 19th century military breech loading rifle, as well as the first breech loading rifle to use a bolt action to open and close the chamber. It was used as the main infantry weapon of the Prussians in the Wars of German Unification. It was invented in 1836 by the German gunsmith Johann Nikolaus von Dreyse (1787–1867), who had been conducting numerous design experiments since 1824. The name "ignition needle rifle" (Zündnadelgewehr) was based on its firing pin, since it passed like a needle through the paper cartridge to strike a percussion cap at the base of the bullet. However, to conceal the revolutionary nature of the design, the rifle entered military service in 1841 as the leichtes Perkussionsgewehr Modell 1841 It had a rate of fire of about six rounds per minute.

The first types of needle gun made by Johann Nikolaus von Dreyse were muzzle loading, with a firing pin consisting of a long needle driven by a coiled conchoidal spring that fired the internal percussion cap on the base of the sabot. His adoption of the bolt action breech loading principle combined with this igniter system gave the rifle its military potential, as these factors allowed a much faster rate of fire. After successful testing in 1840, the Prussian king Friedrich Wilhelm IV ordered 60,000 of the new rifles. Dreyse set up the italic=no factory in Sömmerda with the help of state loans to ramp up production. It was accepted for service in 1841 as the leichtes Perkussionsgewehr Model 1841, but only 45,000 units had been produced by 1848. It was used in combat for the first time during the German revolutions of 1848–49 and proved its combat superiority in street fighting during the May Uprising in Dresden in 1849. Many German states subsequently adopted the weapon. The Sömmerda factory could not meet demand and produced only 30,000 rifles a year. Most of the Prussian infantry in the 1850s were still equipped with the obsolete 1839 Model Potsdam musket, a smoothbore weapon whose range and accuracy was far inferior to the French Minié and Austrian Lorenz rifle. The Prussian Army's low level of funding resulted in just 90 battalions being equipped with the weapon in 1855. Dreyse consented to state manufacture of the rifle to increase production. The Royal Prussian Rifle Factory at the Spandau Arsenal began production in 1853, followed by Danzig, de and Erfurt. At first, the Spandau factory produced 12,000 Dreyse needle guns a year, rising to 48,000 in 1867. The British Army evaluated the Dreyse needle gun in 1849–1851. In the British trials, the Dreyse was shown to be capable of six rounds per minute, and to maintain accuracy at The trials suggested that the Dreyse was "too complicated and delicate" for service use. The French carabine à tige muzzle loading rifle was judged to be a better weapon, and an improved version was adopted as the Pattern 1851 Minié type muzzle loading rifle. The upper end of the paper case is rolled up and tied. Upon release of the trigger, the point of the needle pierces the rear of the cartridge, passes through the powder and hits the primer fixed to the base of the sabot. Thus the burn front in the black powder charge passes from the front to the rear. This front to rear burn pattern minimizes the effect seen in rear igniting cartridges where a portion of the powder at the front of the charge is wasted, as it is forced down and out of the barrel and burns in the air as muzzle flash. It also ensures that the whole charge burns under the highest possible pressure, theoretically minimising unburnt residues. Consequently, a smaller charge can be used to obtain the same velocity as a rear ignited charge of the same bullet calibre and weight. It also increases the handling security of the cartridge, since it is virtually impossible to set the primer off accidentally. There was also a blank cartridge developed for the needle gun. It was shorter and lighter than the live round, since it lacked the projectile, but was otherwise similar in construction and powder load.

British trials in 1849–1851 showed that: This was mainly because a sizable amount of gas escaped at the breech when the rifle was fired with a paper cartridge. An improved model, giving greater muzzle velocity and increased speed in loading, was introduced later, but it was replaced shortly thereafter by the Mauser Model 1871 rifle. The placement of the primer directly behind the bullet meant the firing needle was enclosed in black powder when the gun was fired, causing stress to the pin, which could break over time and render the rifle useless until it could be replaced. Soldiers were provided with two replacement needles for that purpose. The needle could be easily replaced in under 30 seconds, even in the field. Because the rifle used black powder, residue accumulated at the back of the barrel, making cleaning necessary after about 60–80 shots. This was not a large problem because the individual soldier carried fewer cartridges than that and Dreyse created an "air chamber" by having a protruding needle tube. (The Chassepot also had this, but it was more likely to jam after fewer shots because its chamber had a smaller diameter.) A soldier trained before the Austro Prussian War of 1866 had to finish field cleaning in less than 10 minutes.