Өзгертілетін хабарламалы электрондық жол белгісі

Electronic traffic sign with changeable messages

A variable (also changeable , electronic , or dynamic ) message sign or message board, often abbreviated VMS, VMB, CMS, or DMS, and in the UK known as a matrix sign,
is an electronic traffic sign often used on roadways to give travelers information about special events. Such signs warn of traffic congestion, accidents, incidents such as terrorist attacks, AMBER/Silver/Blue Alerts, roadwork zones, or speed limits on a specific highway segment. In urban areas, VMS are used within parking guidance and information systems to guide drivers to available car parking spaces. They may also ask vehicles to take alternative routes, limit travel speed, warn of duration and location of the incidents, inform of the traffic conditions, or display general public safety messages.

VMS systems were deployed at least as early as the 1950s on the New Jersey Turnpike. The NJ Turnpike's signs of that period, and up to around 2012, were capable of displaying a few messages in neon, all oriented around warning drivers to slow down: "REDUCE SPEED", followed by a warning of either construction, accident, congestion, ice, snow, or fog at a certain distance ahead. The New Jersey Turnpike Authority replaced those signs (along with 1990s vintage dot matrix VMS systems along the Garden State Parkway) with more flexible electronic signs between 2010 and 2016. The current VMS systems are largely deployed on freeways, trunk highways, or in work zones. On the interchange of I 5 and SR 120 in San Joaquin County, California, an automated visibility and speed warning system was installed in 1996 to warn traffic of reduced visibility due to fog (where tule fog is a common problem in the winter), and of slow or stopped traffic. Message Signs were deployed in Ontario during the 1990s and are now being upgraded on 400 series highways as well as two pilot secondary highways in northeastern Ontario.

Early variable message signs included static signs with words that would illuminate (often using neon tubing) indicating the type of incident that occurred, or signs that used rotating prisms (trilons) to change the message being displayed. These were later replaced by dot matrix displays typically using eggcrate, fiber optic, or flip disc technology, which were capable of displaying a much wider range of messages than earlier static variable message signs. Since the late 1990s, the most common technology used in new installations for variable message signs are LED displays. In recent years, some newer LED variable message signs have the ability to display colored text and graphics. Dot matrix variable message signs are divided into three subgroups: character matrix, row matrix, and full matrix. In a character matrix VMS, each character is given its own matrix with equal horizontal spacing between them, typically with two or three rows of characters. In a full matrix VMS, the entire sign is a single large dot matrix display, allowing the display of different fonts and graphics. A row matrix VMS is a hybrid of the two types, divided into two or three rows like a character matrix display, except each row is a single long dot matrix display instead of being split per character horizontally. Overhead variable message signs are today available in three form factors: front access, rear access, and walk in. In a front access variable message sign, maintenance is performed by lifting the sign open from the front. Most smaller VMS are of the front access form factor, and are typically installed today on major arterials. The rear access form factor is similar to the front access form factor, except that maintenance is performed from the rear of the sign, and are commonly used for medium sized dynamic message signs installed along the roadside of freeways (instead of overhead). The walk in form factor is a more recent introduction, where maintenance on the sign is performed from the inside of the sign. A key advantage of the walk in form factor is that lane closures are generally not required to perform maintenance on the sign. Most of the largest VMS units installed today are walk in units, and are typically installed overhead on freeways. The NJ Turnpike Authority counts five unique types of variable message signs under its jurisdiction, at least one of which has been replaced by newer signs. They are:

"REDUCE SPEED" neon signs (1950s 2010, obsolete, have been replaced). "Changeable message signs" (trilon/ rotating drum signs that can be used for closing roads or moving traffic to other roadways). Electronic VMS: signs with remotely controlled messages displayed on them; the messages are sent from the State Traffic Management Center, updating the signs automatically. Variable speed limit signs used for varying the posted speed limits within work zones and in emergencies. Portable VMS: movable "electronic VMS". A portable VMS has much the same characteristics as a fixed electronic VMS, but can be moved from location to location as the need dictates.

Truck mounted VMSes (also called Portable Changeable Message Signs or PCMS) are sometimes dispatched by highway agencies such as Caltrans to warn traffic of incidents such as accidents in areas where permanent VMSes are not available or near enough as a preventive measure for reducing secondary accidents. They are often deployed in pairs so that the second VMS truck can take over when the traffic queue overtakes the first truck, requiring the first truck to reposition further upstream from the queue, to be effective. An optional third truck, the team leader, may be utilized for driving by and monitoring the incident itself, traffic patterns and delay times, to make strategic decisions for minimizing delays—analogous to spotter planes used in fighting forest fires. Trailer mounted variable message signs are used to alter traffic patterns near work zones, and for traffic management for special events, natural disasters, and other temporary traffic patterns. The messages displayed on the sign can be programmed locally on the unit's control panel, or units equipped with a cellular modem can be programmed remotely via computer or phone. Most manufacturers produce trailers which comply with the National Transportation Communications for Intelligent Transportation System Protocol (NTCIP) which allows the portable trailer to be integrated with an intelligent transportation system. Trailer mounted VMS can be equipped with radar, cameras, and other sensing devices as part of a smart work zone deployment

A variable message sign figures significantly into the plot of the 1991 film L. A. Story.