История австралийских дорог и развитие транспортной сети.

none

Highways in Australia are generally high capacity roads managed by state and territory government agencies, though Australia's federal government contributes funding for important links between capital cities and major regional centres. Prior to European settlement, the earliest needs for trade and travel were met by narrow bush tracks, used by tribes of Indigenous Australians. The formal construction of roads began in 1788, after the founding of the colony of New South Wales, and a network of three major roads across the colony emerged by the 1820s. Similar road networks were established in the other colonies of Australia. Road construction programs in the early 19th century were generally underfunded, as they were dependent on government budgets, loans, and tolls; while there was a huge increase in road usage, due to the Australian gold rushes. Local government authorities, often known as Road Boards, were therefore established to be primarily responsible for funding and undertaking road construction and maintenance. The early 1900s saw both the increasingly widespread use of motorised transportation, and the creation of state road authorities in each state, between 1913 and 1926. These authorities managed each state's road network, with the main arterial roads controlled and maintained by the state, and other roads remaining the responsibility of local governments. The federal government became involved in road funding in the 1920s, distributing funding to the states. The depression of the 1930s slowed the funding and development of the major road network until the onset on World War II. Supply roads leading to the north of the country were considered vital, resulting in the construction of Barkly, Stuart, and Eyre Highways. The decades following the war saw substantial improvements to the network, with freeways established in cities, many major highways sealed, development of roads in northern Queensland and Western Australia under the Beef Cattle Roads Grants Acts, and interstate routes between Sydney and Melbourne upgraded. In 1974, the federal government assumed responsibility for funding the nations most important road links, between state and territory capitals cities, which were declared National Highways. Some sections of the National Highway system were no more than dirt tracks, while others were four lane dual carriageways. The network was gradually improved, and by 1989, all gravel road sections had been sealed. In the following decades, the National Highway system was amended through legislation, and was eventually superseded in 2005 by the broader National Land Transport Network, which included connections to major commercial centres, and intermodal freight transport facilities. The first route marking system was introduced in the 1950s by the Conference of State Road Authorities, which later became the National Association of Australian State Road Authorities (NAASRA) and then Austroads. National Routes were assigned to significant interstate routes "which, both now and in the future, comprise the more important arteries of road communications throughout Australia in all its aspects". When the National Highway system was introduced, National Routes along it became National Highway routes with the same numbers, but with distinctive green and gold route markers. During the 1990s, planning began for a new alphanumeric route system. Alphanumeric routes have been introduced in most states and territories in Australia, partially or completely replacing the previous systems.

The earliest needs for trade and travel were met by narrow bush tracks, used by tribes of Indigenous Australian prior to European settlement. The formal construction of roads began in 1788, after the founding of the colony of New South Wales. These roads were little more than cleared paths, constructed without grading, drainage systems, and road surfaces. There was no system wide planning for roads, with the Surveyor General's 1788 proposed town plan dismissed as being too ostentatious; however, the arrival of Governor Macquarie in 1810 led to a planned system for roads and bridges, prior to actual settlement of areas, financed from government funds, public subscription, and tolls. By the end of his term in 1822, the colony had a network of three major roads, with the Great Western Road as the most important link, traversing the Blue Mountains from Sydney to Bathurst. Similar road networks were established in the other colonies of Australia. Road construction programs in the early 19th century were generally underfunded, as they were dependent on government budgets, loans, tolls and public subscription. This problem was exacerbated by the huge increase in road usage, due to the Australian gold rushes. Local government authorities were therefore established as authorities primarily responsible for funding and undertaking road construction and maintenance. The increasing amount of motorised transportation in the early 1900s lead to another major increase in traffic levels. The vehicles also required higher standard of roads. In 1988, the National Highway became redefined under the Australian Land Transport Development (ALTD) Act of 1988, which had various amendments up to 2003. The 1988 Act also defined a category of "Road of National Importance", which were partly funded by federal government. The Introduction of the AusLink (National Land Transport) Act in 2005 superseded the National Highway and Roads of National Importance classifications, which were replaced by the National Land Transport Network. The criteria for inclusion in the network was similar to the previous legislation, but expanded to include connections to major commercial centres, and inter modal freight transport facilities. All of the roads included in National Land Transport Network as of 2005 were formally defined by regulation in October 2005. Auslink has since been replaced with subsequent legislation under the federal government's Nation Building Program, which includes the National Land Transport Network. The National Highways road routes developed under the former system are still designated as National Highways on route markers and road guidance signs. However, the new alphanumeric route numbering system introduced to New South Wales and the ACT in 2013 does not distinguish between the former National Highways and other routes. VicRoads have, as of September 2013, similarly deprecated the National Highway route marker in favour of standard routes.

Roads routes in Australia assist drivers navigating roads throughout the country, by identifying important through routes. The first route marking system was introduced to Australia in the 1950s. National Routes were assigned to significant interstate routes – the most important road links in the country. National Route 1 was designated to a circular route around the Australian coastline. A state route marking system was designed to supplement the national system, for inter regional and urban routes within states. In the 1990s Victoria and South Australia also overhauled their systems. While South Australia discarded the National and State Route Numbering Systems, those shield based schemes were retained in the Melbourne metropolitan area as the Metropolitan Route Numbering Scheme. The route numbers used in the alphanumeric schemes were generally inherited from the original National Route Numbering System, with only a few exceptions, and prefixed with letters denoting their grade. For example, Western Freeway is M8 until Ballarat and continues beyond as A8 Western Highway. They are not used extensively in the Melbourne metropolitan area where the blue shield metropolitan route system is retained for most routes. The National Highways were retained, until 2013, At this stage, 4 routes have been fully signed while another one is missing the prefix letter in all of its signs. While there are no immediate plans to introduce an alphanumeric route numbering system in Western Australia, it will begin converting once additional funds become available in the future.

In the alphanumeric systems, a letter denoting the route's construction standard and function is prefixed to the route number, creating an alphanumeric route designation. One of six letters may be used:
"M" routes are primary traffic routes, called motorways in some states. These are typically dual carriageway, freeway standard highways, but may also be used for rural roads that are nearly at freeway standard, or at least are dual carriageways. Arterial roads: These roads serve long distance travellers within or between districts, and support large volumes of traffic. They may be limited access, or controlled access. A small number of these roads have relatively high levels of property access due to city design requirements at the time. Major collector roads: These roads serve local area traffic distributing to or from minor collector roads, and also link to the arterial network. Well designed property access is permissible. Minor collector roads: These roads serve neighbourhood traffic, and provide access from the major collector roads into residential areas. Normal direct property access is permissible at this level. Secondary links to the arterial network are possible. Access streets: These streets are the lowest road type in the hierarchy, and provide access to the bulk of residential homes.

In New South Wales, sections 46, 47, 50 and 51 of the Roads Act 1993 provide for the classifications of Highway, Main Road, Secondary Road or Tourist Road.

In the Northern Territory, major roads are classified into three categories: National Highway, Arterial Roads, and Secondary Roads.

In Queensland, roads are classified as: National Network Roads, State Strategic Roads, Regional Roads, or District Roads.

South Australia's Department of Planning, Transport and Infrastructure (DPTI) classifies state controlled roads into three categories: National Land Transport Network; DPTI Maintained Road, Sealed; and DPTI Maintained Road, Unsealed.