Ford Puma: Үш есікті купе

Small three door coupé
the three door coupé

The Ford Puma is a small car that was produced by Ford Europe from September 1997 to July 2002. The Puma is a three door coupé that is based on the Mark IV Ford Fiesta and was built at Ford's Niehl plant in Cologne, Germany. The Puma follows common design cues with other Ford cars at the time, and is in the New Edge family of vehicles.

The Ford Puma program was initiated in 1993 when then CEO and President of Ford, Jac Nasser and Ford's Small and Medium Vehicle design director Claude Lobo, discussed the possibility of doing a 2+2 coupe based on Fiesta chassis. All development was done using Paintbox CAD system which allowed designers to render a 2D and 3D models. The first iteration of the design, called the Lynx concept car, was unveiled at the Geneva Motor Show in 1996, and production car was launched in 1997 Geneva Motor show.

All Pumas are front engined, front wheel drive, three door coupés with four seats. They came with alloy wheels as standard, (although the Ford Racing Puma was equipped with alloy wheels), with front disc and rear drum brakes. The car was based on the Mark 4 Ford Fiesta, with new engines (codeveloped with Yamaha), a new body, stiffer suspension, wider track and close ratio gearbox, among other changes. The Puma was available with four engine options: 1.4 litre (1997 2000), 1.6 litre (2000 2001), 1.7 litre VCT (only used in the Puma), and the Tickford tuned 1.7 litre VCT (which was only used in the Ford Racing Puma), each of which used Ford's 16 v Sigma engines branded as Zetec SE. Additionally, the 1.7 litre engines used Nikasil cylinder plating, which required a specific grade of oil (5W30 semisynthetic) to minimise mechanical wear. The production journey of the 1.7 litre VCT was quite interesting. Rough machined cylinder blocks were shipped from Ford's Valencia plant in Spain to Yamaha in Japan for Nikasil coating and completion. These were then shipped back to Ford's Cologne plant where the Puma was assembled. All 1.7 litre engined Pumas were equipped with low speed traction control and antilock brakes. The antilock braking system was optional in the 1.4 litre Puma. During the relatively short production run, approximately 133,000 Pumas were built (all models including the Ford Racing Puma). At its peak, 52,950 were registered with the DVLA in the UK, which has since reduced to 7,493 (including 5,457 that have statutory off road notification (SORN)) as of Q3 2023.

Engine, litre (cm3)PowerTorque0–100 km/h (0 62 mph)Top speed1.4 (1388) 16 V @ 5500 rpm10.8 s1.6 (1596) 16 V @ 6000 rpm10.1 s1.7 (1679) 16 V VCT @ 6300 rpm9.2 s1.7 (1679) 16 V VCT @ 7000 rpm7.9 s

For the Racing Puma, Ford partnered with Alcon Design to produce a 4 Piston Motorsport braking system. The Alcon Racing Front Brake calipers use x 28mm discs (253mm discs on the rear). These brakes are one of the defining attributes of the Racing Puma and they contribute significantly to enabling the standard car to pull a substantial 1.1g+ of braking force in the dry. This compares well to the normal Puma's ability to achieve 0.7g on regular, smaller, x brake discs and calipers. The brake calipers themselves, being derived from a racing set up, do not come fitted with any protective rubber boots which prevent brake dust and debris from coming into contact with the brake pistons. This means the brakes should be serviced regularly (fully dismantled and properly cleaned) to maintain efficiency. Furthermore, the inner portions of the caliper were unpainted aluminium, and are susceptible to corrosion.

The bodywork was beefed up with wider, lightweight aluminium front and steel rear overhangs; these covered a substantially widened track at both the front and rear, requiring longer drive shafts unique to the Racing Puma. A front aerodynamic air splitter and modified wider front bumper with sports grill were used. The wheels are MiM Speedline alloys, 17 x 7.5 in (with an ET28 Offset) and use 215/40 17 tyres (original fitment tyres were Michelin SXGT 215/40 R17), this increases the width from 1674 mm to 1770 mm. The S1600 rally Puma is just 35 mm wider than this. The Racing Puma's suspension was developed and honed by Ford's specialist division at Boreham, Essex, and the cars' monocoque shell was originally designed to be Ford's WRC entrant. Stig Blomqvist spent months fine tuning the car's handling to ensure its chassis dynamics were perfected. The wider track, uprated springs, dampers, and special geometry settings refined the car's cornering poise to another level beyond the standard car's already excellent handling. The upshot of the improved chassis finesse was a bias towards tracks, hence the car has a very firm ride. All Racing Pumas left the factory painted metallic Imperial Blue to signify their special racing edition status. This colour was only used by Ford on a select range of cars such as the Ford Escort Cosworth and Mk.1 Ford Focus RS edition models. The colour was not available on the regular Pumas in the UK market.

The standard IB5 gearbox was strengthened on the Racing Puma in comparison to the standard models. It contains modified shafts, which have been shot peened to withstand the extra load placed upon them. This allowed a revised Power train Control Module software to be used, allowing more power and torque to be used in lower gears. Additionally, Ford Racing offered an optional limited slip differential to enhance handling even further, only 75 customer cars actually came equipped with that option from factory, but since then, subsequent owners have been known to retrofit it.

Sparco were commissioned to provide high grip bucket seats for improved driver control in cornering situations. The blue Alcantara trim used on the seats and steering wheel provided improved grip over other material types. The door cards, rear seats, and rear interior were also trimmed with the same material, and the front seats were embroidered with the Ford Racing emblem.

The original design remit was to achieve 180 bhp using a 1.7 litre Zetec SE equipped with a turbocharger. However, due to spiralling project costs, this was not achieved and eventually the Racing Puma engineers were forced to keep their changes within a naturally aspirated engine. The majority of the engine remained unchanged from the 1.7 Zetec SE used in the standard Puma. Only the camshafts, air intake (with the unique edition number engraved on it), a specially tuned complete exhaust system by Janspeed, and a revised engine management software helped to increase power by 30 hp, reducing the 0 time to 7.8 seconds, achieving a 126 mph (203 km/h) top speed.

Ford produced a Ford Puma kit car, which was designed specifically for rallying. The Puma's technical details included a Zetec SE all alloy engine with four cylinders and 16 valves at 1596 cm3, power over at 9000 rpm, front wheel drive via a Hewland six speed sequential gearbox, limited slip differential, dynamic front suspension using MacPherson struts with adjustable spring platforms, Ford Racing rear trailing arm beam with adjustable dynamic suspension, Alcon front brakes with diameter ventilated discs using four piston calipers, Alcon diameter solid disc rear brakes with two piston calipers, a welded steel safety roll cage, and front and rear wheel arches and bumpers in composite. The fuel tank was a 55 litre capacity FIA 'bag' tank located beneath the rear floor. Wheels were Tarmac 7 x 17 in aluminium wheels or 6 x 15 in aluminium wheels for gravel.

Stylistically, the Puma followed Ford's New Edge design strategy, as first seen in the 1996 Ford Ka. While not as controversial as the Ka when it first appeared, the Puma did achieve critical acclaim for its well proportioned and cat like design cues. The Puma was memorable for its pan European launch campaign that featured Steve McQueen. The original United Kingdom television advertisement used clips from the movie Bullitt and cut McQueen into the modern setting of a Puma in San Francisco. In Q4 2004, Ford once again used the McQueen footage for the first 2005 Ford Mustang commercial in the United States. Both commercials were directed by British director Paul Street, and won many advertising industry awards, featuring in all time top 10 ad charts.

The Puma was only sold in Europe. Production ended in 2001, although sale of stock vehicles continued into 2002. Ford did not replace it with another small coupé, and instead introduced the Ford StreetKa, a two seater convertible based on the Fiesta like the Puma was. The StreetKa also borrowed the Puma's transmission and suspension. There are 7,493 Ford Pumas (including cars declared as SORN) that remain registered with the DVLA in the UK as of Q3 2023. 1999 – Design Council Millennium Products award for "The first Ford in Britain designed solely on computer and in record time." 2001 – What Car? : Used Sports Car of the Year – Ford Puma 1.7
2004 – What Car? : Best Used Sporting Car of the Year Under £10,000 – Ford Puma 1.7
2011 – What Car? : Best "Gem For Under £1,000" – Ford Puma 1.7