Scalar field theory

Field theory of scalar fields
In theoretical physics, scalar field theory can refer to a relativistically invariant classical or quantum theory of scalar fields. A scalar field is invariant under any Lorentz transformation. The only fundamental scalar quantum field that has been observed in nature is the Higgs field. However, scalar quantum fields feature in the effective field theory descriptions of many physical phenomena. An example is the pion, which is actually a pseudoscalar. Since they do not involve polarization complications, scalar fields are often the easiest to appreciate second quantization through. For this reason, scalar field theories are often used for purposes of introduction of novel concepts and techniques. The signature of the metric employed below is (+, −, −, −).

A general reference for this section is Ramond, Pierre (2001 12 21). Field Theory: A Modern Primer (Second Edition). USA: Westview Press. , Ch 1.

The most basic scalar field theory is the linear theory. Through the Fourier decomposition of the fields, it represents the normal modes of an infinity of coupled oscillators where the continuum limit of the oscillator index i is now denoted by x. The action for the free relativistic scalar field theory is then

where is known as a Lagrangian density; d^(4−1)x ≡ dx ⋅ dy ⋅ dz ≡ dx^(1) ⋅ dx^(2) ⋅ dx^(3) for the three spatial coordinates; δ^(ij) is the Kronecker delta function; and for the ρ th coordinate x^(ρ). This is an example of a quadratic action, since each of the terms is quadratic in the field, φ. The term proportional to m^(2) is sometimes known as a mass term, due to its subsequent interpretation, in the quantized version of this theory, in terms of particle mass. The equation of motion for this theory is obtained by extremizing the action above. It takes the following form, linear in φ,

where ∇2 is the Laplace operator. This is the Klein–Gordon equation, with the interpretation as a classical field equation, rather than as a quantum mechanical wave equation.

Physical quantities in these scalar field theories may have dimensions of length, time or mass, or some combination of the three. However, in a relativistic theory, any quantity t, with dimensions of time, can be readily converted into a length, , by using the velocity of light, c. Similarly, any length l is equivalent to an inverse mass, , using Planck's constant, ħ. In natural units, one thinks of a time as a length, or either time or length as an inverse mass. In short, one can think of the dimensions of any physical quantity as defined in terms of just one independent dimension, rather than in terms of all three. This is most often termed the mass dimension of the quantity. Knowing the dimensions of each quantity, allows one to uniquely restore conventional dimensions from a natural units expression in terms of this mass dimension, by simply reinserting the requisite powers of ħ and c required for dimensional consistency. One conceivable objection is that this theory is classical, and therefore it is not obvious how Planck's constant should be a part of the theory at all. If desired, one could indeed recast the theory without mass dimensions at all: However, this would be at the expense of slightly obscuring the connection with the quantum scalar field. Given that one has dimensions of mass, Planck's constant is thought of here as an essentially arbitrary fixed reference quantity of action (not necessarily connected to quantization), hence with dimensions appropriate to convert between mass and inverse length.

There is a specific sense in which some scalar field theories are scale invariant. While the actions above are all constructed to have zero mass dimension, not all actions are invariant under the scaling transformation

The reason that not all actions are invariant is that one usually thinks of the parameters m and gn as fixed quantities, which are not rescaled under the transformation above. The condition for a scalar field theory to be scale invariant is then quite obvious: all of the parameters appearing in the action should be dimensionless quantities. In other words, a scale invariant theory is one without any fixed length scale (or equivalently, mass scale) in the theory. For a scalar field theory with D spacetime dimensions, the only dimensionless parameter gn satisfies n = For example, in D = 4, only g4 is classically dimensionless, and so the only classically scale invariant scalar field theory in D = 4 is the massless φ4 theory. Classical scale invariance, however, normally does not imply quantum scale invariance, because of the renormalization group involved – see the discussion of the beta function below.

The φ4 theory with a negative m2 also has a kink solution, which is a canonical example of a soliton. Such a solution is of the form

where x is one of the spatial variables (φ is taken to be independent of t, and the remaining spatial variables). The solution interpolates between the two different vacua of the double well potential. It is not possible to deform the kink into a constant solution without passing through a solution of infinite energy, and for this reason the kink is said to be stable. For D>2 (i. e., theories with more than one spatial dimension), this solution is called a domain wall. Another well known example of a scalar field theory with kink solutions is the sine Gordon theory.

In a complex scalar field theory, the scalar field takes values in the complex numbers, rather than the real numbers. The complex scalar field represents spin 0 particles and antiparticles with charge. The action considered normally takes the form

This has a U(1), equivalently O(2) symmetry, whose action on the space of fields rotates , for some real phase angle α. As for the real scalar field, spontaneous symmetry breaking is found if m2 is negative. This gives rise to Goldstone's Mexican hat potential which is a rotation of the double well potential of a real scalar field through 2π radians about the V axis. The symmetry breaking takes place in one higher dimension, i. e., the choice of vacuum breaks a continuous U(1) symmetry instead of a discrete one. The two components of the scalar field are reconfigured as a massive mode and a massless Goldstone boson.

One can express the complex scalar field theory in terms of two real fields, φ1 = Re φ and φ2 = Im φ, which transform in the vector representation of the U(1) = O(2) internal symmetry. Although such fields transform as a vector under the internal symmetry, they are still Lorentz scalars. This can be generalised to a theory of N scalar fields transforming in the vector representation of the O(N) symmetry. The Lagrangian for an O(N) invariant scalar field theory is typically of the form

using an appropriate O(N) invariant inner product. The theory can also be expressed for complex vector fields, i. e. for , in which case the symmetry group is the Lie group SU(N).

When the scalar field theory is coupled in a gauge invariant way to the Yang–Mills action, one obtains the Ginzburg–Landau theory of superconductors. The topological solitons of that theory correspond to vortices in a superconductor; the minimum of the Mexican hat potential corresponds to the order parameter of the superconductor.