Студебекер US6: Американский грузовик для Советской Армии

American exported military cargo vehicle

The Studebaker US6 (G630) was a series of 2 1/2 ton 6×6 and 5 ton 6×4 trucks manufactured by the Studebaker Corporation and REO Motor Car Company during World War II. The basic cargo version was designed to transport a cargo load over any type of terrain in any weather. Most of these were exported to the Soviet Union under Lend Lease by the US during World War II, since the competing GMC 6×6 CCKW design proved to be more suitable for Western Front conditions.

In 1939–1940, the US Army Ordnance Corps was developing tactical 6×6 trucks that could operate off road in all weather. Studebaker, Yellow Coach (a GM company) and International Harvester all submitted designs that were accepted and went into production in 1941. A total of 219,882 2 1/2 ton 6×6 trucks and similar 6×4 versions in 13 variations were built. Studebaker was the primary manufacturer, which built 197,678 of them at its South Bend, Indiana plant, while Reo produced 22,204 more at its Lansing, Michigan plant from 1944 under a sub contract. Reo trucks are identical to Studebakers, but Reo built only cargo model trucks with the long wheelbase and without the front mounted winch, more specifically referred to as the US6 U9. All production by both manufacturers ended in 1945.

The US6 was manufactured primarily for export under Lend Lease. The Soviet Union would become the largest foreign operator. The first Studebaker US6 trucks arrived in the USSR in the autumn of 1941. The Red Army organized a test of eleven 6×6 US6 trucks which took place between July 1942 and May 1943. The results were used to direct the enlargement of the payload from In 1945, it was lowered to , although on improved roads they could carry up to a maximum of
Large numbers of Studebaker US6 trucks were supplied to the Soviet Union via the Persian Corridor in Iran under the US's Lend Lease program. The truck fulfilled many important roles in service with Soviet military forces during the war, such as towing artillery pieces and anti tank guns and transporting troops over long distances. It was renowned for its overall ruggedness and reliability, including its ability to run on poor quality fuel. The Soviet Red Army also found them to be a suitable platform for conversion into Katyusha rocket launchers, although this was not their main purpose. The truck became affectionately known as the Studer by Soviet troops and was even recognised of its importance (to the Soviet war effort) by Joseph Stalin, who sent a personal letter of appreciation to Studebaker, in which he thanked it for the superb quality of the US6 for Soviet service. Studebaker US6 trucks were also used by the US military in the construction of the Ledo Road in Burma, and the Alcan Highway in North America, during WWII.

The US6 used a Hercules JXD engine, with an L head inline 6 cylinder gasoline engine developing at 2,800 rpm and of torque at 1,150 rpm. A conservative type and highly reliable engine with a compression ratio of only 5.82:1, it could use 68 octane gasoline. This same engine was also used in the M3 Scout Car and, later, M8 Greyhound and M20 armoured cars (the latter was a variant (lacking the gun turret) of the M8 Greyhound). The Warner T 93 5 speed transmission had a very low first, a direct fourth and an overdrive fifth gear. A power take off could be fitted to operate a winch (mounted just below in front of the radiator) and/or the hydraulic hoist on dump trucks. The Timken T 79 transfer case had high and low ranges, a neutral position and could either engage or disengage the front axle. There was one output shaft mounted forward to the front axle (not used in 6×4 trucks) and two to the rear, with one for each rear axle. Both front and rear axles were of the Timken split type with a ratio of 6.6:1. The front axle had ball type constant velocity joints while the two at the rear were full floating.

The US6 had a ladder frame with three beam axles, the front on semi elliptical leaf springs, the rear tandem on quarter elliptical leaf springs with locating arms. There were two wheelbases, the short , used in semi tractors, dump trucks, and short cargo models, and the long , used in tankers, long cargo models, and the U9 chassis cab. All models had 7.50 20" tires and dual rear tires. 6×4 models, intended for on road use only, were rated at , twice the 6×6's off road rating.

The US6 carried the design of Studebaker's civilian truck cab, although it was modified for military use. Studebaker trucks were different from other 2 1/2 6×6 trucks built for the war effort of the UA because vent windows were included in each door. These vent windows were separate from the main window that rolled down into the door frame and could be swung out to help with the truck cab's ventilation. Studebaker also designed the open type military truck cab which was featured on the GMC CCKW (later models), but their major customer, the USSR, preferred the closed cab for their generally harsh (cold weather) climate. While Studebaker's open type truck cab became the American standard, production of the US6 with the closed type truck cab was restarted after only 10,000 units of the former.

The U1 and the U2 cargo trucks (which had a frontally mounted winch) had a short wheelbase and the spare tire was mounted behind the cab, thus allowing a truck bed measuring only 2.74 m long. These "prime mover" style bodies were not a success as the US6 was to be mainly used for transporting cargo. The U3/U4 and the 6×4 U7/U8 cargo trucks had a longer wheelbase, which allowed the spare tire to be mounted under the 3.66 m truck bed. 197,000 trucks with the 3.66 m truck bed were built. The U5 tank truck had a long wheelbase and a two compartment tank mounted on the truck bed. Tanker trucks were not equipped with winches. The 6×4 U6 semi tractor was the only semi tractor version in the entire US6 truck series. Semi tractors have limited off road performance and, therefore, the U6 was rated for a 5 ton load on improved roads. For this same reason, they had no frontally mounted winch. The U9 cargo truck had a long wheelbase and lacked a frontally mounted winch. The Soviet Katyusha multiple rocket launcher could be mounted on their truck beds

The U10/U11 (end type) and the U12/U13 (side type) dump trucks had a short wheelbase. Both types had the dump body mounted on a sub frame at the rear of the truck, with the end type dump having a hydraulic cylinder attached to the chassis with a lever arrangement while the side type dump had the hydraulic cylinder mounted directly to the truck body.

Model Wheelbase Length Width Height Weight empty U1 Cargo (U2 with winch) Short 6.10 m 2.13 m 2.44 m U3 Cargo (long) (U4 with winch) Long 8.23 m 2.13 m 2.44 m U5 Tank Long 6.10 m 2.13 m 2.13 m U6 Tractor Short (6×4) 5.18 m 2.13 m 2.13 m U7 Cargo (long) (U8 with winch) Long (6×4) 8.23 m 2.13 m 2.44 m U9 Cab/chassis Long 2.13 m 2.13 m U10 End dump (U11 with winch) Short 5.49 m 2.13 m 2.13 m U12 Side dump (U13 with winch) Short 5.49 m 2.13 m 2.13 m

Some Studebaker US6 trucks that were shipped to the Soviet Union during WWII and decommissioned from service after 1945 had their cabs and plumage taken off and used in the prototypes of the GAZ 51 truck, which eventually underwent mass production in 1946. The construction of the Studebaker US6 strongly influenced the construction of the postwar ZIS 151 truck, which then evolved into the ZIL 157 truck which remained in production up until 1994. The Studebaker US6 truck became a legendary vehicle with its Soviet operators at the time and was called the "King of Roads" by soldiers due to their reliability and dependability, and is still popular in Russian vehicle collector circles and clubs. In the United States, these trucks are seen as the symbol for the Lend Lease program to the USSR.